On 07/25/2017 08:09 AM, Bob Sneidar via use-livecode wrote:
Thanks Monte, but I do not use modal any more than I can help it. This is
happening in virtually every script I have. As I mentioned, I had one script
where the breakpoints pane reported that the script had a breakpoint on line 6
hundred something, and there have never been any more that 200 lines in the
script. I think that the recorded breakpoint moves when the script is saved,
but the displayed red dot remains where it is. I can fix it by clicking to turn
off the red dot then clicking again to turn it on.
I have also noted that after turning off breakpoints in all my scripts, the
breakpoint tab of the SE still reports breakpoints in different scripts. When I
go to check for those breakpoints, they do not exist.
In the message box, type "put the breakpoints" and see if that helps.
Also the virtual breakpoints are stored as custom properties (the
cREVGeneral["breakpoints"]) of stacks, so check there to see if there's
anything that shouldn't be there.
As a last resort, if you're seeing line numbers that obviously aren't in
your script, then the IDE's debugger may be misinterpreting the behavior
extension in the executionContexts and referencing a behavior script
somewhere else.
--
Mark Wieder
ahsoftw...@gmail.com
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
