Thanks Pete, I was hoping that was the answer. This particular project
is LC-7 exclusive, so the two arrayEncodings won't be a problem. In
fact, I'm going to ignore it altogether. :)
On 8/14/2015 1:37 PM, Peter Haworth wrote:
I've done that without textEncode and it worked fine. Just watch out for
the two arrayencoding algorithms used in different lc versions.
On Fri, Aug 14, 2015 at 11:32 AM J. Landman Gay <jac...@hyperactivesw.com>
wrote:
I haven't got the materials yet so I can't test, but I am about to write
a script that saves an array to a file on disk using arrayEncode (LC 7.)
This is strictly for LC use; it will be saved and then re-loaded into
the stack on next launch. Do I need to textEncode the data if I'm not
going to use it outside of LC? I'm assuming it will remain intact but
wanted to check.
--
Jacqueline Landman Gay | jac...@hyperactivesw.com
HyperActive Software | http://www.hyperactivesw.com
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your
subscription preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
--
Jacqueline Landman Gay | jac...@hyperactivesw.com
HyperActive Software | http://www.hyperactivesw.com
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
