Make sure you put the message to be sent in quotes: send "magicgatemouseup" ...
Regards, Scott Rossi Creative Director Tactile Media, UX/UI Design On 5/13/13 5:26 PM, "kee nethery" <k...@kagi.com> wrote: >-- use a > >send magicgatemouseup to stack "mystack" in 120 seconds > > >-- then in your stack > >on magicgatemouseup > processRequest > if condition is not met then > send magicgatemouseup to stack "mystack" in 120 seconds > end if >end magicgatemouseup > > >On May 13, 2013, at 5:21 PM, Magicgate Software - Skip Kimpel ><s...@magicgate.com> wrote: > >> I am having a hard time researching a solution since most of the forums >>are >> down :) Here is my issue, hopefully somebody has the simple answer to >>my >> question... >> >> I have a script that runs every two minutes and I have been calling it >>with: >> >> on mouseUp >> wait for 120 seconds >> processRequest >> end mouseUp >> >> I then call a repeat script that keeps checking for the status and >> repeating it until a condition is met. Obviously when I do this it >>locks >> up my software until the condition has been satisfied. >> >> How can I do this without locking everything up? >> _______________________________________________ >> use-livecode mailing list >> use-livecode@lists.runrev.com >> Please visit this url to subscribe, unsubscribe and manage your >>subscription preferences: >> http://lists.runrev.com/mailman/listinfo/use-livecode > > >_______________________________________________ >use-livecode mailing list >use-livecode@lists.runrev.com >Please visit this url to subscribe, unsubscribe and manage your >subscription preferences: >http://lists.runrev.com/mailman/listinfo/use-livecode > _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode
