Not sure at this point. When I open a sub stack called “Devices” (or any sub stack) of my main stack “Forms Generator” and I enter “put the defaultStack” in the message box, I get “Forms Generator”.
If I put the command “put the defaultStack” in the last line of the openStack handler of stack devices, I get “Devices”. Right afterwards, if I enter “put the defaultStack” in the message box, I get “Forms Generator” again! Not entirely sure what is doing it. Had the same issue with another much simpler stack. If I went invisible to a database setup stack, then went back to the stack that called it, the defaultStack remained the database setup stack, and THAT wasn’t even a sub stack! Until I can figure out what is causing it, I cannot trust the defaultStack. Bob S > On Apr 18, 2020, at 9:53 AM, dunbarx--- via use-livecode > <use-livecode@lists.runrev.com> wrote: > > Bob. > I make a new stack "XXX", and a substack "YYY", and save the lot. To be sure, > I quit LC and open "XXX" from the desktop. > There is a single button on "XXX" that:on mouseUp go stack"yyy"answer the > defaultStackend mouseUp > I get "YYY" > What are you seeing? > Craig _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode
