Thank you Monte!
I just finished dinner and was sitting down to enter a new bug when I
saw you had already done it!
On 5/16/2019 6:30 PM, Monte Goulding via use-livecode wrote:
On 17 May 2019, at 7:29 am, Monte Goulding via use-livecode
<[email protected]> wrote:
I just added an updated test stack that showed another issue of only a single
file type is specified. If you have have a chance could you check that the fix
addresses that use case too?
I think it would be best to open a separate report about the inconsistency when
there’s only a single type specified. The original report is a clear regression
from the refactor while the difference between mac and win when only a single
type is specified was always the case I think. We need to figure out whether to
document the inconsistency or fix for one platform or the other. Note that this
command setting both it and the result is actually a documented anomaly so
perhaps if we have the choice the result should be cleared.
I opened this separate issue for the platform inconsistency issue which is
worse on Linux as it doesn’t set the result at all
https://quality.livecode.com/show_bug.cgi?id=22071
<https://quality.livecode.com/show_bug.cgi?id=22071>
_______________________________________________
use-livecode mailing list
[email protected]
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
_______________________________________________
use-livecode mailing list
[email protected]
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
