there was a bug once (8 series probably, can't remember) with the
Message Box and then opening the Message Watcher crashing the IDE. I
reported it myself. But i can't find it anymore at quality.
I believe it was solved then. Maybe there is a regression.
Op 21-2-2019 om 19:04 schreef J. Landman Gay via use-livecode:
If the message box is misdirecting commands, that may fit with some
problems I've seen too. I couldn't set behavior on a button, menu key
shortcuts fail all the time, and calling a handler from the message
box periodically reports the handler can't be found even though the
message box title field says the target stack is the one I'm looking
at. Also, like you, Cmd-S periodically fails to do anything and
contextual menus don't appear when right-clicking.
I open the message box at startup and never close it.
--
Jacqueline Landman Gay | jac...@hyperactivesw.com
HyperActive Software | http://www.hyperactivesw.com
On February 20, 2019 10:32:52 PM Ralph DiMola via use-livecode
<use-livecode@lists.runrev.com> wrote:
A new twist. A ctrl S will work normally until I open the message
box. The
inspector will also open OK. Open up the message box and close it. Now a
ctrl S will cause the message box to open(last command is displayed
but not
executed) then the stack will be saved normally. Also the inspector
will no
longer open. Close the message box and do a Ctrl S and again the
message box
opens up. Strange indeed.
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your
subscription preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
_______________________________________________
use-livecode mailing list
use-livecode@lists.runrev.com
Please visit this url to subscribe, unsubscribe and manage your subscription
preferences:
http://lists.runrev.com/mailman/listinfo/use-livecode
