--untested repeat for the number of cards add one to x repeat for the number of controls add one to y --add saveguards against deleting your own stuff set the custompropertyset of control y of card x to "" end repeat end repeat
also check out the preferences general tab: "show livecode ui elements in stacks", shows crevgeneral custom properties too. On 27 May 2011, at 00:32, william humphrey wrote: > If I comment out: > > " put the bottom of control ID tObjectRef + tDistance into item 2 of > tObjectRect" > > > it solves the problem but the next time I update LiveCode that will be back > the way it was again. There must be some other way to turn off revGeometry. > > On Thu, May 26, 2011 at 6:27 PM, william humphrey < > b...@bluewatermaritime.com> wrote: > >> How do you repeat through every control structure in a card and remove any >> revGeometry that it might have? >> >> >> On Thu, May 26, 2011 at 4:44 PM, william humphrey < >> b...@bluewatermaritime.com> wrote: >> >>> What calls: revUpdateGeometry? I have a simple button that goes to >>> particular card in a stack and I keep getting errors in >>> revUpdateGeometry. >>> >>> revUpdateGeometry >>> >>> >>> chunk: no such object >>> >>> Object btn "revGeometryBack" of grp "revLibraries" >>> >>> >>> I don't use revGeometry anywhere as far as I know so I wonder how to debug >>> this liveCode error? >>> >> >> >> >> -- >> http://www.bluewatermaritime.com >> > > > > -- > http://www.bluewatermaritime.com > _______________________________________________ > use-livecode mailing list > use-livecode@lists.runrev.com > Please visit this url to subscribe, unsubscribe and manage your subscription > preferences: > http://lists.runrev.com/mailman/listinfo/use-livecode _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode
