J Bond 0.07 wrote: > c.kumsta wrote: >> Perso, pour entrer des IP en fixe, je le fais directement dans le >> fichier "/etc/network/interfaces" >> Par exemple, dans ton cas : >> ======================================== >> auto lo >> iface lo inet loopback >> >> auto eth0 >> iface eth0 inet static >> address 192.168.0.4 >> netmask 255.255.255.0 >> >> auto eth2 >> iface eth1 inet static >> address 192.168.88.1 >> netmask 255.255.255.0 >> ======================================== > > Mon fichier interfaces : > This file describes the network interfaces available on your system > # and how to activate them. For more information, see interfaces(5). > > # The loopback network interface > auto lo eth2 > iface lo inet loopback > > # This is a list of hotpluggable network interfaces. > # They will be activated automatically by the hotplug subsystem. > mapping hotplug > script grep > map eth2 > > # The primary network interface > > iface eth2 inet static > address 192.168.88.1 > netmask 255.255.255.0 > gateway 192.168.1.4 > > > > > auto dsl-provider > iface dsl-provider inet ppp > pre-up /sbin/ifconfig eth2 up # line maintained by pppoeconf > provider dsl-provider > > auto eth0:avah > iface eth0:avah inet manual > > #auto eth1 > > > #auto eth0 > > > #auto eth2 > > > #auto eth2 > > iface eth1 inet static > address 192.168.1.4 > netmask 255.255.255.0 > gateway 192.168.1.1 > > auto eth1 > > iface eth0 inet static > address 192.168.1.4 > netmask 255.255.255.0 > gateway 192.168.0.50 > > auto eth0 >> >> (à mon avis, ce n'est pas la peine de rajouter de champs "gateway" >> étant donné que c'est ta connexion vers ton FAI >> qui va le régler au moment de la négociation avec ton FAI sur ppp0) >> >> ++dune2 >> >> [EMAIL PROTECTED]:~$ sudo ifconfig > eth0 Lien encap:Ethernet HWaddr 00:13:8F:7A:C6:DD > inet adr:192.168.1.4 Bcast:192.168.1.255 Masque:255.255.255.0 > UP BROADCAST MULTICAST MTU:1500 Metric:1 > Packets reçus:0 erreurs:0 :0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 lg file transmission:1000 > Octets reçus:0 (0.0 b) Octets transmis:0 (0.0 b) > Interruption:16 Adresse de base:0xc000 > > eth1 Lien encap:Ethernet HWaddr 00:18:E7:07:F9:F4 > inet adr:192.168.1.4 Bcast:192.168.1.255 Masque:255.255.255.0 > adr inet6: fe80::218:e7ff:fe07:f9f4/64 Scope:Lien > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > Packets reçus:45 erreurs:0 :0 overruns:0 frame:0 > TX packets:7 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 lg file transmission:1000 > Octets reçus:11692 (11.4 KB) Octets transmis:528 (528.0 b) > Interruption:19 Adresse de base:0x2800 > > eth2 Lien encap:Ethernet HWaddr 00:10:A7:0C:8B:55 > inet adr:192.168.88.1 Bcast:192.168.88.255 Masque:255.255.255.0 > adr inet6: fe80::210:a7ff:fe0c:8b55/64 Scope:Lien > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > Packets reçus:4653 erreurs:0 :0 overruns:0 frame:0 > TX packets:4201 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 lg file transmission:1000 > Octets reçus:3285428 (3.1 MB) Octets transmis:465510 (454.5 KB) > Interruption:20 Adresse de base:0xec00 > > lo Lien encap:Boucle locale > inet adr:127.0.0.1 Masque:255.0.0.0 > adr inet6: ::1/128 Scope:Hôte > UP LOOPBACK RUNNING MTU:16436 Metric:1 > Packets reçus:408 erreurs:0 :0 overruns:0 frame:0 > TX packets:408 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 lg file transmission:0 > Octets reçus:33437 (32.6 KB) Octets transmis:33437 (32.6 KB) > > ppp0 Lien encap:Protocole Point-à-Point > inet adr:194.206.79.171 P-t-P:195.146.243.10 > Masque:255.255.255.255 > UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1 > Packets reçus:4345 erreurs:0 :0 overruns:0 frame:0 > TX packets:3825 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 lg file transmission:3 > Octets reçus:3171290 (3.0 MB) Octets transmis:357454 (349.0 KB) > > [EMAIL PROTECTED]:~$ > > ufconfig est bon, maintenant! > [EMAIL PROTECTED]:~$ sudo route > Table de routage IP du noyau > Destination Passerelle Genmask Indic Metric Ref Use > Iface > lns2.l0.10.143. * 255.255.255.255 UH 0 0 0 > ppp0 > 192.168.1.0 * 255.255.255.0 U 0 0 0 > eth0 > 192.168.1.0 * 255.255.255.0 U 0 0 0 > eth1 > 192.168.88.0 * 255.255.255.0 U 0 0 0 > eth2 > link-local * 255.255.0.0 U 1000 0 0 > eth1 > default * 0.0.0.0 U 0 0 0 > ppp0 > [EMAIL PROTECTED]:~$ > > ça devrait marcher et ça marche pas : les ping sont perdus. > > Je regarde maintenant du coté des hosts et hosts.allow! : > > hosts: > 127.0.0.1 localhost > # > # The following lines are desirable for IPv6 capable hosts > ::1 ip6-localhost ip6-loopback > fe00::0 ip6-localnet > ff00::0 ip6-mcastprefix > ff02::1 ip6-allnodes > ff02::2 ip6-allrouters > ff02::3 ip6-allhosts > 192.168.88.3 violette > 192.168.1.1 modem > 192.168.0.50 dlink > 192.168.88.5 lombric > 192.168.1.4 crapaud.chikungugna.org > > hosts.allow : > /etc/hosts.allow: list of hosts that are allowed to access the system. > # See the manual pages hosts_access(5) and > hosts_options(5). > # > # Example: ALL: LOCAL @some_netgroup > # ALL: .foobar.edu EXCEPT terminalserver.foobar.edu > # > # If you're going to protect the portmapper use the name "portmap" for the > # daemon name. Remember that you can only use the keyword "ALL" and IP > # addresses (NOT host or domain names) for the portmapper, as well as for > # rpc.mountd (the NFS mount daemon). See portmap(8) and rpc.mountd(8) > # for further information. > # > 192.168.88.3 violette > 192.168.88.5 lombric > 192.168.1.1 modem > 192.168.0.50 dlink > ALL: LOCAL @chikungugna.org > 192.168.1.4 crapaud.chikungugna.org > > Où est l'erreur? : ça devient compliqué, et le tuto n'est peut etre pas > trop clair.. > > Feb 23 08:59:52 moustique dhcpd: All rights reserved. Feb 23 08:59:52 moustique dhcpd: For info, please visit http://www.isc.org/sw/dhcp/ Feb 23 08:59:52 moustique dhcpd: Wrote 0 leases to leases file. Feb 23 08:59:52 moustique dhcpd: Feb 23 08:59:52 moustique dhcpd: No subnet declaration for eth1 (192.168.1.4). Feb 23 08:59:52 moustique dhcpd: ** Ignoring requests on eth1. If this is not what Feb 23 08:59:52 moustique dhcpd: you want, please write a subnet declaration Feb 23 08:59:52 moustique dhcpd: in your dhcpd.conf file for the network segment Feb 23 08:59:52 moustique dhcpd: to which interface eth1 is attached. ** Feb 23 08:59:52 moustique dhcpd: Feb 23 08:59:52 moustique dhcpd: Feb 23 08:59:52 moustique dhcpd: No subnet declaration for eth0 (192.168.1.4). Feb 23 08:59:52 moustique dhcpd: ** Ignoring requests on eth0. If this is not what Feb 23 08:59:52 moustique dhcpd: you want, please write a subnet declaration Feb 23 08:59:52 moustique dhcpd: in your dhcpd.conf file for the network segment Feb 23 08:59:52 moustique dhcpd: to which interface eth0 is attached. ** Feb 23 08:59:52 moustique dhcpd: Feb 23 08:59:52 moustique dhcpd: Can't bind to dhcp address: Address already in use Feb 23 08:59:52 moustique dhcpd: Please make sure there is no other dhcp server Feb 23 08:59:52 moustique dhcpd: running and that there's no entry for dhcp or Feb 23 08:59:52 moustique dhcpd: bootp in /etc/inetd.conf. Also make sure you Feb 23 08:59:52 moustique dhcpd: are not running HP JetAdmin software, which Feb 23 08:59:52 moustique dhcpd: includes a bootp server. Feb 23 08:59:52 moustique avahi-daemon[7568]: Server startup complete. Host name is moustique.local. Local service cookie is 3633587936. Feb 23 09:00:20 moustique hald: mounted /dev/sdc1 on behalf of uid 1000 Feb 23 09:00:21 moustique hcid[7610]: Default passkey agent (:1.20, /org/bluez/passkey) registered Feb 23 09:00:21 moustique hcid[7610]: Default authorization agent (:1.20, /org/bluez/auth) registered Feb 23 09:00:23 moustique NetworkManager: <info> Updating allowed wireless network lists. Feb 23 09:00:23 moustique NetworkManager: <WARN> nm_dbus_get_networks_cb(): error received: org.freedesktop.NetworkManagerInfo.NoNetworks - There are no wireless networks stored.. Feb 23 09:04:07 moustique ntpd[7539]: synchronized to 91.189.94.4, stratum 2 Feb 23 09:04:07 moustique ntpd[7539]: time reset -0.509176 s Feb 23 09:04:07 moustique ntpd[7539]: kernel time sync status change 0001 Feb 23 09:09:48 moustique ntpd[7539]: synchronized to 91.189.94.4, stratum 2
-- ubuntu-fr mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-fr
