And after setting the audio-input to the tuner (0) with
/usr/bin/v4l2-ctl -d /dev/video0 --set-audio-input=0 I still get no
sound out of the card.

I have a USB webcam but even when I cold boot without the webcam pluged
in the pvr-150 does not give me any audio ......

[EMAIL PROTECTED]:~$ ls /dev/video*
/dev/video0  /dev/video24  /dev/video32

[EMAIL PROTECTED]:~$ dmesg | grep ivtv
[   48.329807] ivtv:  Start initialization, version 1.1.0
[   48.329870] ivtv0: Initializing card #0
[   48.329872] ivtv0: Autodetected Hauppauge card (cx23416 based)
[   48.368245] ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
[   48.444361] ivtv0: Autodetected Hauppauge WinTV PVR-150
[   48.554829] tuner 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
[   48.558106] tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
[   48.588909] cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
[   48.612326] wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
[   48.620978] ivtv0: Registered device video0 for encoder MPG (4096 kB)
[   48.620998] ivtv0: Registered device video32 for encoder YUV (2048 kB)
[   48.621015] ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
[   48.621032] ivtv0: Registered device video24 for encoder PCM (320 kB)
[   48.621048] ivtv0: Registered device radio0 for encoder radio
[   48.621050] ivtv0: Initialized card #0: Hauppauge WinTV PVR-150
[   48.621062] ivtv:  End initialization
[   56.815283] ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
[   57.013635] ivtv0: Encoder revision: 0x02060039

The exact same hardware worked fine under 7.10.  Any other suggestions?

-- 
Hauppauge PVR-150 with no audio after upgrading to Hardy
https://bugs.launchpad.net/bugs/228363
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to