Hello, I can confirm this bug. Hardy Heron thinks my original WG511 card is a softmac card (which uses the p54 driver), when it fact it is a hardmac card, which uses the prism54 driver.
Here is the relevant dmesg output when the (incorrect) p54 driver is loaded: [ 88.629267] cs: IO port probe 0xa00-0xaff: clean. [ 90.104775] PCI: Enabling device 0000:02:00.0 (0000 -> 0002) [ 90.104821] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKA] -> GSI 11 (lev el, low) -> IRQ 11 [ 90.104871] PCI: Setting latency timer of device 0000:02:00.0 to 64 [ 91.651421] p54: LM86 firmware [ 91.651445] p54: FW rev 2.7.0.0 - Softmac protocol 4.1 [ 91.778047] phy0: Selected rate control algorithm 'simple' [ 92.162754] phy0: hwaddr 00:09:5b:98:3a:72, isl3890 ... [ 121.245798] ADDRCONF(NETDEV_UP): wlan0: link is not ready this message keeps getting appended to dmesg from that point on: [ 176.094145] phy0: tx overflow. [ 176.094172] phy0: tx overflow. [ 176.182548] phy0: tx overflow. [ 176.182581] phy0: tx overflow. [ 176.271226] phy0: tx overflow. [ 176.271273] phy0: tx overflow. Here is the dmesg output under Knoppix 5.1.1, where the correct prism54 driver is loaded: Loaded prism54 driver, version 1.2 eth1: resetting device... eth1: uploading firmware... eth1: firmware version: 1.0.4.3 eth1: firmware upload complete eth1: interface reset complete here's my uname: [EMAIL PROTECTED]:~/bug# uname -a Linux ibm 2.6.24-16-generic #1 SMP Thu Apr 10 13:23:42 UTC 2008 i686 GNU/Linux [EMAIL PROTECTED]:~/bug# my lspci is attached ** Attachment added: "lspci -vvnn" http://launchpadlibrarian.net/14351241/lspci-vvnn.log -- Netgear WG511 not detected https://bugs.launchpad.net/bugs/224579 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
