Setting [EMAIL PROTECTED] helps me too with LG Flatron Wide L206WTQ at Intel
945
$ sudo ddcprobe
vbe: VESA 3.0 detected.
oem: Intel(r) 82945G Chipset Family Graphics Chip Accelerated VGA BIOS
vendor: Intel Corporation
product: Intel(r) 82945G Chipset Family Graphics Controller Hardware Version 0.0
memory: 7872kb
mode: 1280x1024x256
mode: 1280x1024x64k
mode: 1280x1024x16m
mode: 1024x768x256
mode: 1024x768x64k
mode: 1024x768x16m
mode: 640x480x16m
mode: 800x600x64k
mode: 800x600x16m
mode: 640x480x256
mode: 800x600x256
mode: 640x480x64k
edid:
edid: 1 3
id: 4e69
eisa: GSM4e69
serial: 0001655d
manufacture: 4 2007
input: separate sync, sync on green, analog signal.
screensize: 43 27
gamma: 2.200000
dpms: RGB, active off, suspend, standby
timing: [EMAIL PROTECTED] Hz (VGA 640x400, IBM)
timing: [EMAIL PROTECTED] Hz (XGA2)
timing: [EMAIL PROTECTED] Hz (VGA)
timing: [EMAIL PROTECTED] Hz (VESA)
timing: [EMAIL PROTECTED] Hz (VESA)
timing: [EMAIL PROTECTED] Hz (VESA)
timing: [EMAIL PROTECTED] Hz (VESA)
timing: [EMAIL PROTECTED] Hz Interlaced (8514A)
timing: [EMAIL PROTECTED] Hz (VESA)
timing: [EMAIL PROTECTED] Hz (VESA)
ctiming: [EMAIL PROTECTED]
ctiming: [EMAIL PROTECTED]
ctiming: [EMAIL PROTECTED]
ctiming: [EMAIL PROTECTED]
ctiming: [EMAIL PROTECTED]
dtiming: [EMAIL PROTECTED]
dtiming: [EMAIL PROTECTED]
monitorrange: 30-83, 56-75
monitorname: L206WTQ
$ sudo get-edid | parse-edid
parse-edid: parse-edid version 1.4.1
get-edid: get-edid version 1.4.1
Performing real mode VBE call
Interrupt 0x10 ax=0x4f00 bx=0x0 cx=0x0
Function supported
Call successful
VBE version 300
VBE string at 0x11110 "Intel(r) 82945G Chipset Family Graphics Chip
Accelerated VGA BIOS"
VBE/DDC service about to be called
Report DDC capabilities
Performing real mode VBE call
Interrupt 0x10 ax=0x4f15 bx=0x0 cx=0x0
Function supported
Call successful
Monitor and video card combination does not support DDC1 transfers
Monitor and video card combination supports DDC2 transfers
0 seconds per 128 byte EDID block transfer
Screen is not blanked during DDC transfer
Reading next EDID block
VBE/DDC service about to be called
Read EDID
Performing real mode VBE call
Interrupt 0x10 ax=0x4f15 bx=0x1 cx=0x0
Function supported
Call successful
parse-edid: EDID checksum passed.
# EDID version 1 revision 3
Section "Monitor"
# Block type: 2:0 3:fd
# Block type: 2:0 3:fc
Identifier "L206WTQ"
VendorName "GSM"
ModelName "L206WTQ"
# Block type: 2:0 3:fd
HorizSync 30-83
VertRefresh 56-75
# Max dot clock (video bandwidth) 150 MHz
# Block type: 2:0 3:fc
# DPMS capabilities: Active off:yes Suspend:yes Standby:yes
Mode "1680x1050" # vfreq 59.883Hz, hfreq 64.674kHz
DotClock 119.000000
HTimings 1680 1728 1760 1840
VTimings 1050 1053 1059 1080
Flags "-HSync" "+VSync"
EndMode
Mode "1680x1050" # vfreq 59.954Hz, hfreq 65.290kHz
DotClock 146.250000
HTimings 1680 1784 1960 2240
VTimings 1050 1053 1059 1089
Flags "+HSync" "-VSync"
EndMode
# Block type: 2:0 3:fd
# Block type: 2:0 3:fc
EndSection
** Attachment added: "xorg.conf"
http://launchpadlibrarian.net/12623695/xorg.conf
--
Screen extends beyond physical edges of monitor
https://bugs.launchpad.net/bugs/116514
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
