Hi,

I installed Ubuntu 20.04.1 LTS on my XPS9310.

Enabled developper updates:

with
deb http://ch.archive.ubuntu.com/ubuntu/ focal-proposed main restricted 
universe multiverse

and then followed these instructions:
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1879633/comments/43

after reboot the wifi was detected.
Unfortunately this is not stable and crashes either immediately or after a few 
minutes of usage.
And usually the laptop freezes after a while and becomes very very hot.

Here the kernel logs

Dec 22 18:25:06 xps9310 kernel: [    9.251416] ath11k_pci 0000:55:00.0: 
WARNING: ath11k PCI support is experimental!
Dec 22 18:25:06 xps9310 kernel: [    9.251716] ath11k_pci 0000:55:00.0: BAR 0: 
assigned [mem 0x8e300000-0x8e3fffff 64bit]
Dec 22 18:25:06 xps9310 kernel: [    9.251735] ath11k_pci 0000:55:00.0: 
enabling device (0000 -> 0002)
Dec 22 18:25:06 xps9310 kernel: [    9.251824] ath11k_pci 0000:55:00.0: MSI 
vectors: 1

Dec 22 18:25:06 xps9310 kernel: [    9.496982] ath11k_pci 0000:55:00.0: qmi req 
mem_seg[0] 0x27800000 3522560 1
Dec 22 18:25:06 xps9310 kernel: [    9.496985] ath11k_pci 0000:55:00.0: qmi req 
mem_seg[1] 0x27e00000 884736 4
Dec 22 18:25:06 xps9310 kernel: [    9.503636] ath11k_pci 0000:55:00.0: chip_id 
0x0 chip_family 0xb board_id 0xff soc_id 0xffffffff
Dec 22 18:25:06 xps9310 kernel: [    9.503637] ath11k_pci 0000:55:00.0: 
fw_version 0x101c06cc fw_build_timestamp 2020-06-24 19:50 fw_build_id 

Dec 22 18:25:06 xps9310 kernel: [    9.673746] ath11k_pci 0000:55:00.0
wlp85s0: renamed from wlan0

Dec 22 18:25:37 xps9310 kernel: [   40.859652] ath11k_pci 0000:55:00.0: 
firmware crashed: MHI_CB_SYS_ERROR
Dec 22 18:26:00 xps9310 kernel: [   63.561197] ath11k_pci 0000:55:00.0: failed 
to receive scan abort comple: timed out
Dec 22 18:26:00 xps9310 kernel: [   63.561202] ath11k_pci 0000:55:00.0: failed 
to abort scan: -110
Dec 22 18:26:00 xps9310 kernel: [   63.562134] wlp85s0: authenticate with 
78:8a:20:4a:ea:ca
Dec 22 18:26:03 xps9310 kernel: [   66.629275] ath11k_pci 0000:55:00.0: wmi 
command 16387 timeout
Dec 22 18:26:03 xps9310 kernel: [   66.629280] ath11k_pci 0000:55:00.0: failed 
to send WMI_PDEV_SET_PARAM cmd
Dec 22 18:26:03 xps9310 kernel: [   66.629287] ath11k_pci 0000:55:00.0: failed 
to recalc txpower limit 24 using pdev param 3: -11
Dec 22 18:26:06 xps9310 kernel: [   69.701276] ath11k_pci 0000:55:00.0: wmi 
command 20488 timeout
Dec 22 18:26:06 xps9310 kernel: [   69.701281] ath11k_pci 0000:55:00.0: failed 
to send WMI_VDEV_SET_PARAM_CMDID
Dec 22 18:26:06 xps9310 kernel: [   69.701288] ath11k_pci 0000:55:00.0: Failed 
to set beacon interval for VDEV: 0
^@^@^@^@^@
.........
@^@^@^@^@^@Dec 22 19:11:03 xps9310 kernel: [    0.000000] Linux version 
5.8.0-34-generic (buildd@lcy01-amd64-015) (gcc (Ubuntu 9.3.0-17ubuntu1~20.04) 
9.3.0, GNU ld (GNU Binutils for Ubuntu) 2.34) #37~20.04.2-Ubuntu SMP Thu Dec 17 
14:53:00 UTC 2020 (Ubuntu 5.8.0-34.37~20.04.2-generic 5.8.18)


Attached my dmidecode


** Attachment added: "xps9310_dmidecode.xz"
   
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1879633/+attachment/5446777/+files/xps9310_dmidecode.xz

-- 
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1879633

Title:
  Killer 500s (QCA6390) WLAN/BT [17cb:1101] unavailable

To manage notifications about this bug go to:
https://bugs.launchpad.net/hwe-next/+bug/1879633/+subscriptions

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to