** Description changed:

  ubuntu 18.04 update  r8168_8.047.01.orig.tar
  
  it doesn't work
  
  root@ton-ThinkPad:/home/ton# lshw -c network
    *-network
         description: Ethernet interface
         product: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
         vendor: Realtek Semiconductor Co., Ltd.
         physical id: 0
         bus info: pci@0000:02:00.0
         logical name: enp2s0
         version: 03
         serial: 08:9e:01:2b:ea:86
         size: 1Gbit/s
         capacity: 1Gbit/s
         width: 64 bits
         clock: 33MHz
         capabilities: pm msi pciexpress msix vpd bus_master cap_list rom 
ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
         configuration: autonegotiation=on broadcast=yes driver=r8168 
driverversion=8.047.01-NAPI duplex=full ip=192.168.31.202 latency=0 link=yes 
multicast=yes port=twisted pair speed=1Gbit/s
         resources: irq:26 ioport:a000(size=256) memory:d0004000-d0004fff 
memory:d0000000-d0003fff memory:d0400000-d041ffff
    *-network
         description: Wireless interface
         product: RTL8191SEvB Wireless LAN Controller
         vendor: Realtek Semiconductor Co., Ltd.
         physical id: 0
         bus info: pci@0000:03:00.0
         logical name: wlp3s0
         version: 10
         serial: 88:9f:fa:f8:ff:b8
         width: 32 bits
         clock: 33MHz
         capabilities: pm msi pciexpress bus_master cap_list ethernet physical 
wireless
         configuration: broadcast=yes driver=rtl8192se 
driverversion=4.18.0-15-generic firmware=N/A latency=0 link=no multicast=yes 
wireless=IEEE 802.11
         resources: irq:18 ioport:b000(size=256) memory:d0300000-d0303fff
  
  root@ton-ThinkPad:/home/ton# nmcli dev show
  GENERAL.DEVICE:                         enp2s0
  GENERAL.TYPE:                           ethernet
  GENERAL.HWADDR:                         08:9E:01:2B:EA:86
  GENERAL.MTU:                            1500
  GENERAL.STATE:                          100 (已连接)
  GENERAL.CONNECTION:                     有线连接 1
  GENERAL.CON-PATH:                       
/org/freedesktop/NetworkManager/ActiveCo
  WIRED-PROPERTIES.CARRIER:               开启
  IP4.ADDRESS[1]:                         192.168.31.202/24
  IP4.GATEWAY:                            192.168.31.1
  IP4.ROUTE[1]:                           dst = 0.0.0.0/0, nh = 192.168.31.1, 
mt =
  IP4.ROUTE[2]:                           dst = 192.168.31.0/24, nh = 0.0.0.0, 
mt
  IP4.ROUTE[3]:                           dst = 169.254.0.0/16, nh = 0.0.0.0, 
mt =
  IP4.DNS[1]:                             192.168.31.1
  IP6.ADDRESS[1]:                         fe80::57d4:8f0a:1241:312f/64
  IP6.GATEWAY:                            --
  IP6.ROUTE[1]:                           dst = ff00::/8, nh = ::, mt = 256, 
table
  IP6.ROUTE[2]:                           dst = fe80::/64, nh = ::, mt = 256
  IP6.ROUTE[3]:                           dst = fe80::/64, nh = ::, mt = 100
  
  GENERAL.DEVICE:                         wlp3s0
  GENERAL.TYPE:                           wifi
  GENERAL.HWADDR:                         88:9F:FA:F8:FF:B8
  GENERAL.MTU:                            1500
  GENERAL.STATE:                          30 (已断开)
  GENERAL.CONNECTION:                     --
  GENERAL.CON-PATH:                       --
  
  GENERAL.DEVICE:                         lo
  GENERAL.TYPE:                           loopback
  GENERAL.HWADDR:                         00:00:00:00:00:00
  GENERAL.MTU:                            65536
  GENERAL.STATE:                          10 (未托管)
  GENERAL.CONNECTION:                     --
  GENERAL.CON-PATH:                       --
  IP4.ADDRESS[1]:                         127.0.0.1/8
  IP4.GATEWAY:                            --
  IP6.ADDRESS[1]:                         ::1/128
  IP6.GATEWAY:                            --
  IP6.ROUTE[1]:                           dst = ::1/128, nh = ::, mt = 256
  lines 18-40/40 (END)
  
  root@ton-ThinkPad:/home/ton# networkctl
  WARNING: systemd-networkd is not running, output will be incomplete.
  
  IDX LINK             TYPE               OPERATIONAL SETUP
    1 lo               loopback           n/a         unmanaged
    2 enp2s0           ether              n/a         unmanaged
    3 wlp3s0           wlan               n/a         unmanaged
  
  3 links listed.
  
  C:\Users\willi>ping 192.168.31.202
  
  正在 Ping 192.168.31.202 具有 32 字节的数据:
  来自 192.168.31.241 的回复: 无法访问目标主机。
  来自 192.168.31.241 的回复: 无法访问目标主机。
  来自 192.168.31.241 的回复: 无法访问目标主机。
  来自 192.168.31.241 的回复: 无法访问目标主机。
  
  192.168.31.202 的 Ping 统计信息:
      数据包: 已发送 = 4,已接收 = 4,丢失 = 0 (0% 丢失),
  
  C:\Users\willi>
  
  (I just want see a <Avengers: Endgame> on TV use ubuntu samba to
  sharing, why it doesn't work?)
+ 
+ 
+ I installed the official driver(GBE Ethernet LINUX driver r8168 for
+ kernel up to 4.15   8.047   2019/08/02      107 KB),it can work,but,it
+ need hardware connected Display ,it can not work if it didn't connect
+ display.(Ubuntu 18.04.3 LTS,Desktop)

-- 
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1838190

Title:
  it doesn't work

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/r8168/+bug/1838190/+subscriptions

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to