Public bug reported:
[Impact]
BT fails to enable again after disabled it by hotkey with the following message
Bus 001 Device 004: ID 8087:0029 Intel Corp.
[248987.643125] usb 1-10: device descriptor read/64, error -110
[249003.247721] usb 1-10: device descriptor read/64, error -110
[249003.483611] usb 1-10: reset full-speed USB device number 4 using xhci_hcd
[249018.855466] usb 1-10: device descriptor read/64, error -110
[249034.467589] usb 1-10: device descriptor read/64, error -110
[249034.703574] usb 1-10: reset full-speed USB device number 4 using xhci_hcd
[249045.299399] usb 1-10: device not accepting address 4, error -62
[249045.427510] usb 1-10: reset full-speed USB device number 4 using xhci_hcd
[249050.675715] usb 1-10: Device not responding to setup address.
[249050.883541] usb 1-10: device not accepting address 4, error -71
[Fix]
Found the updated firmware fixes the issue
[Test]
Verify on the machine couple days, and can't duplicate the issue anymore.
[Regression Potential]
Low, the system keeps running for 5 days, and pass s3 tests 30 times,
everything works well.
** Affects: linux-firmware (Ubuntu)
Importance: Undecided
Status: In Progress
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1835345
Title:
[Intel CyclonePeak] Can not turn on BT after turn off (via Hotkey)
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux-firmware/+bug/1835345/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
