this is happening on a system using 10G Intel NIC:
05:00.0 Ethernet controller: Intel Corporation Ethernet Controller 10-Gigabit 
X540-AT2 (rev 01)

root@host:~# ethtool enp129s0f0
Settings for enp129s0f0:
        Supported ports: [ FIBRE ]
        Supported link modes:   10000baseT/Full 
        Supported pause frame use: Symmetric
        Supports auto-negotiation: No
        Advertised link modes:  10000baseT/Full 
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: No
        Speed: 10000Mb/s
        Duplex: Full
        Port: Direct Attach Copper
        PHYAD: 0
        Transceiver: external
        Auto-negotiation: off
        Supports Wake-on: d
        Wake-on: d
        Current message level: 0x00000007 (7)
                               drv probe link
        Link detected: yes

On a different host using on board Broadcom 1G interfaces (and the
same automated install system) interface (in this case en01) comes up
properly as expected (on the same network in the same rack using the
same dhcp server):

04:00.0 Ethernet controller: Broadcom Limited NetXtreme BCM5720 Gigabit
Ethernet PCIe

root@other-host:~# ethtool eno1
Settings for eno1:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Half 1000baseT/Full 
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Half 1000baseT/Full 
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: Yes
        Link partner advertised link modes:  10baseT/Half 10baseT/Full 
                                             100baseT/Half 100baseT/Full 
                                             1000baseT/Full 
        Link partner advertised pause frame use: Symmetric
        Link partner advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: off
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
                               drv probe link timer ifdown ifup rx_err tx_err
        Link detected: yes

-- 
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1726912

Title:
  fails to keep dhcplease

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/nplan/+bug/1726912/+subscriptions

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to