------- Comment From thorsten.di...@de.ibm.com 2016-05-04 10:17 EDT-------
I installed Ubuntu 16.04 on an FBA device. When the partman menu appeared, I
created a new partition table on DASD 0.0.ede0 (FBA), and then I created two
partitions: 0.7G ext4 for /boot and 10G ext4 for /.
Installation proceeded ok, and the system ipled from EDEV EDE0. All fine.
During a 2nd installation on the same device the following problem occured:
After activation of the previously installed EDEV disk, partman shows one
single full size partition, which is not correct:
? DASD 0.0.ede0 (FBA ) - 10.7 GB IBM S390 DASD drive
?
? > #1 10.7 GB
?
while kernel has the correct info:
~ # cat /proc/partitions |grep dasd
94 0 10485760 dasda
94 1 683584 dasda1
94 2 9801984 dasda2
Continuing with the installation from here results in a system IPL that ends up
in an initramfs, since the rootfs could not be mounted due to an incorrect
partition table.
Attaching syslog.
Until this bug is fixed, I recommend to describe the workaround (when
installing on EDEV DASD it is highly recommended to create an empty
partition table on the entire device before partitioning) in the release
notes.
Maybe you can have a look info LTC bug 137464 / LP1548411 which
described a similar problem with vdisks under KVM.
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1578232
Title:
Support statement for packages within Ubuntu 16.04 LTS should have the
5 Y statement
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+bug/1578232/+subscriptions
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
