Confirmed on my new install of dapper fo an ASUS M2NPV-VM mainboard. After boot, the ethernet port doesn't work. I noticed this on my initial install, then dropped in an old 3com card which works fine. Now I should have two ethernet ports but *three* are reported! The built-in port (using forcedeth) does not work.
$ dmesg | grep -i eth [ 24.485083] Driver 'sd' needs updating - please use bus_type methods [ 26.609318] forcedeth.c: Reverse Engineered nForce ethernet driver. Version 0.54. [ 26.864101] forcedeth: using HIGHDMA [ 27.385899] eth0: forcedeth.c: subsystem: 01043:816a bound to 0000:00:14.0 [ 33.676120] eth1: no link during initialization. [ 62.004674] ADDRCONF(NETDEV_UP): eth1: link is not ready [ 62.004676] ADDRCONF(NETDEV_UP): eth2: link is not ready [ 74.880935] eth1: link up. [ 74.882667] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready [ 85.144040] eth1: no IPv6 routers present [ 391.385594] eth1: link down. [ 398.161365] eth2: Setting full-duplex based on MII #24 link partner capability of 0061. [ 398.162811] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready [ 408.465608] eth2: no IPv6 routers pre -- Ethernet interface not working after reboot https://launchpad.net/bugs/42608 -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
