Oh. I guess that's not a module any more, because I'm behind the times
on my legacy IPv4 network. :)
So, to check if this is the problem, you can temporarily disable IPv6:
sauer@pyro:~$ ip addr show lo
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
sauer@pyro:~$ sudo sysctl net.ipv6.conf.all.disable_ipv6
net.ipv6.conf.all.disable_ipv6 = 0
sauer@pyro:~$ sudo sysctl -w net.ipv6.conf.all.disable_ipv6=1
net.ipv6.conf.all.disable_ipv6 = 1
sauer@pyro:~$ ip addr show lo
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
Note that the IPv6 translation address pops up on all interfaces when the
disable setting is 0, and goes away immediately when the disable setting is set
to 1. To make this permanent on 12.04, create a file named
/etc/sysctl.conf.d/60-disableipv6.conf and add a line that says
net.ipv6.conf.all.disable_ipv6 = 1. I'm partial to running:
sauer@pyro:~$ echo "net.ipv6.conf.all.disable_ipv6 = 1" | sudo tee
/etc/sysctl.d/60-disableipv6.conf
net.ipv6.conf.all.disable_ipv6 = 1
The setting in that file will take effect when you reboot or reload the sysctl
settings by running "sudo start procps".
This is still a bug in Precise, IMHO. If IPv6 is going to be enabled by
default on the systems, then the Ping6 command should be set in backuppc.pl
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/782890
Title:
no ping response on all hosts after upgrade
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/backuppc/+bug/782890/+subscriptions
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
