[ 146.292030] usb 1-5: new high speed USB device using ehci_hcd and address 4 [ 146.425250] usb 1-5: configuration #1 chosen from 1 choice [ 146.488976] cdc_acm 1-5:1.1: ttyACM0: USB ACM device [ 146.491252] usbcore: registered new interface driver cdc_acm [ 146.491257] cdc_acm: v0.26:USB Abstract Control Model driver for USB modems and ISDN adapters [ 146.507579] NET: Registered protocol family 35 [ 146.513680] cdc_phonet: probe of 1-5:1.10 failed with error -22 [ 146.513710] usbcore: registered new interface driver cdc_phonet [ 146.530120] usbcore: registered new interface driver cdc_ether [ 146.534860] usb 1-5: bad CDC descriptors [ 146.534899] usbcore: registered new interface driver rndis_host [ 146.571658] cfg80211: Calling CRDA to update world regulatory domain [ 146.583107] usb 1-5: bad CDC descriptors [ 146.583172] usbcore: registered new interface driver rndis_wlan [ 146.610188] cfg80211: World regulatory domain updated: [ 146.610193] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 146.610198] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 146.610202] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 146.610207] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 146.610211] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 146.610215] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 157.160114] PPP BSD Compression module registered [ 157.184678] PPP Deflate Compression module registered [ 168.468840] end_request: I/O error, dev fd0, sector 0 [ 180.653054] end_request: I/O error, dev fd0, sector 0 [ 741.720035] usb 1-6: new high speed USB device using ehci_hcd and address 5 [ 741.904301] hub 1-0:1.0: unable to enumerate USB device on port 6 [ 742.732312] hub 1-0:1.0: unable to enumerate USB device on port 6 [ 743.636012] usb 1-6: new high speed USB device using ehci_hcd and address 7 [ 743.962905] usb 1-6: configuration #1 chosen from 1 choice [ 744.057521] Initializing USB Mass Storage driver... [ 744.057881] scsi4 : SCSI emulation for USB Mass Storage devices [ 744.058021] usbcore: registered new interface driver usb-storage [ 744.058025] USB Mass Storage support registered. [ 744.061987] usb-storage: device found at 7 [ 744.061989] usb-storage: waiting for device to settle before scanning [ 744.621517] usb 1-6: USB disconnect, address 7 [ 745.188026] usb 1-6: new high speed USB device using ehci_hcd and address 8 [ 745.322866] usb 1-6: configuration #1 chosen from 1 choice [ 745.323185] scsi5 : SCSI emulation for USB Mass Storage devices [ 745.323429] usb-storage: device found at 8 [ 745.323432] usb-storage: waiting for device to settle before scanning [ 746.021369] usb 1-6: USB disconnect, address 8 [ 746.952032] usb 1-6: new high speed USB device using ehci_hcd and address 9 [ 747.086904] usb 1-6: configuration #1 chosen from 1 choice [ 747.087664] scsi6 : SCSI emulation for USB Mass Storage devices [ 747.087909] usb-storage: device found at 9 [ 747.087912] usb-storage: waiting for device to settle before scanning [ 747.097277] usb 1-6: USB disconnect, address 9 [ 747.400034] usb 1-6: new high speed USB device using ehci_hcd and address 10 [ 747.534979] usb 1-6: configuration #1 chosen from 1 choice [ 747.535732] scsi7 : SCSI emulation for USB Mass Storage devices [ 747.535981] usb-storage: device found at 10 [ 747.535984] usb-storage: waiting for device to settle before scanning [ 752.532192] usb-storage: device scan complete [ 752.542066] scsi 7:0:0:0: Direct-Access JetFlash TS1GJFV30 8.07 PQ: 0 ANSI: 2 [ 752.542759] sd 7:0:0:0: Attached scsi generic sg2 type 0 [ 752.546646] sd 7:0:0:0: [sdb] 1986558 512-byte logical blocks: (1.01 GB/969 MiB) [ 752.547165] sd 7:0:0:0: [sdb] Write Protect is off [ 752.547171] sd 7:0:0:0: [sdb] Mode Sense: 03 00 00 00 [ 752.547175] sd 7:0:0:0: [sdb] Assuming drive cache: write through [ 752.550378] sd 7:0:0:0: [sdb] Assuming drive cache: write through [ 752.550389] sdb: sdb1 [ 752.555916] sd 7:0:0:0: [sdb] Assuming drive cache: write through [ 752.555923] sd 7:0:0:0: [sdb] Attached SCSI removable disk [ 1318.301411] usb 1-6: USB disconnect, address 10 [ 1989.892012] usb 4-2: new full speed USB device using uhci_hcd and address 2 [ 1990.125198] usb 4-2: configuration #1 chosen from 1 choice [ 1990.193072] Linux video capture interface: v2.00 [ 1990.204248] gspca: main v2.7.0 registered [ 1990.205791] gspca: probing 093a:2460 [ 1990.208183] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 1990.208186] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 1990.210203] gspca: probe ok [ 1990.210220] usbcore: registered new interface driver pac207 [ 1990.210410] pac207: registered [ 1991.200540] usb 4-2: USB disconnect, address 2 [ 1991.200719] gspca: disconnect complete [ 1991.440514] usb 4-2: new full speed USB device using uhci_hcd and address 3 [ 1991.496537] hub 4-0:1.0: unable to enumerate USB device on port 2 [ 1992.096512] usb 4-2: new full speed USB device using uhci_hcd and address 4 [ 1992.326564] usb 4-2: configuration #1 chosen from 1 choice [ 1992.329506] gspca: probing 093a:2460 [ 1992.333057] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 1992.333060] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 1992.334535] gspca: probe ok [ 1994.584040] usb 4-2: USB disconnect, address 4 [ 1994.584213] gspca: disconnect complete [ 1995.712519] usb 4-2: new full speed USB device using uhci_hcd and address 5 [ 1995.942146] usb 4-2: configuration #1 chosen from 1 choice [ 1995.945098] gspca: probing 093a:2460 [ 1995.948044] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 1995.948047] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 1995.950121] gspca: probe ok [ 1997.472544] usb 4-2: USB disconnect, address 5 [ 1997.472720] gspca: disconnect complete [ 1997.712515] usb 4-2: new full speed USB device using uhci_hcd and address 6 [ 1997.944465] usb 4-2: configuration #1 chosen from 1 choice [ 1997.948369] usb 4-2: can't set config #1, error -71 [ 1998.184540] usb 4-2: USB disconnect, address 6 [ 2001.116535] usb 4-2: new full speed USB device using uhci_hcd and address 7 [ 2001.345901] usb 4-2: configuration #1 chosen from 1 choice [ 2001.348844] gspca: probing 093a:2460 [ 2001.351776] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 2001.351778] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 2001.353850] gspca: probe ok [ 2003.512536] usb 4-2: USB disconnect, address 7 [ 2003.512714] gspca: disconnect complete [ 2005.792511] usb 4-2: new full speed USB device using uhci_hcd and address 8 [ 2006.021882] usb 4-2: configuration #1 chosen from 1 choice [ 2006.024851] gspca: probing 093a:2460 [ 2006.027791] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 2006.027794] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 2006.029857] gspca: probe ok [ 2007.276520] hub 1-0:1.0: unable to enumerate USB device on port 6 [ 2007.276539] usb 4-2: USB disconnect, address 8 [ 2007.276711] gspca: disconnect complete [ 2008.216514] usb 4-2: new full speed USB device using uhci_hcd and address 9 [ 2008.446283] usb 4-2: configuration #1 chosen from 1 choice [ 2008.449229] gspca: probing 093a:2460 [ 2008.452176] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 2008.452179] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 2008.454250] gspca: probe ok [ 2010.972527] usb 4-2: USB disconnect, address 9 [ 2010.972707] gspca: disconnect complete [ 2012.068525] hub 1-0:1.0: unable to enumerate USB device on port 6 [ 2012.580515] usb 4-2: new full speed USB device using uhci_hcd and address 10 [ 2012.809991] usb 4-2: configuration #1 chosen from 1 choice [ 2012.812943] gspca: probing 093a:2460 [ 2012.815892] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 2012.815895] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 2012.817963] gspca: probe ok [ 2013.720541] usb 4-2: USB disconnect, address 10 [ 2013.720714] gspca: disconnect complete [ 2013.960516] usb 4-2: new full speed USB device using uhci_hcd and address 11 [ 2014.190215] usb 4-2: configuration #1 chosen from 1 choice [ 2014.193165] gspca: probing 093a:2460 [ 2014.196108] pac207: Pixart Sensor ID 0x27 Chips ID 0x09 [ 2014.196111] pac207: Pixart PAC207BCA Image Processor and Control Chip detected (vid/pid 0x093A:0x2460) [ 2014.198182] gspca: probe ok [ 2014.672535] usb 4-2: USB disconnect, address 11 [ 2014.672714] gspca: disconnect complete
-- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/710455 Title: Sigma micro webcam not detected -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
