With 2.6.32-02063208-generic #02063208 SMP Wed Feb 10 10:10:27 UTC 2010 x86_64 GNU/Linux (http://kernel.ubuntu.com/~kernel-ppa/mainline/v2.6.32.8/) I still have problems. The connection works only for some time (10 minutes? 15?) than also if ping to router works html navigation doesn't work.
dmesg [ 80.170140] cfg80211: Calling CRDA to update world regulatory domain [ 80.248137] cfg80211: World regulatory domain updated: [ 80.248145] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 80.248153] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 80.248160] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 80.248167] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 80.248174] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 80.248180] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 80.284909] ACPI: PCI Interrupt Link [LN3A] enabled at IRQ 19 [ 80.284923] alloc irq_desc for 19 on node -1 [ 80.284930] alloc kstat_irqs on node -1 [ 80.284947] ath9k 0000:04:00.0: PCI INT A -> Link[LN3A] -> GSI 19 (level, low) -> IRQ 19 [ 80.284964] ath9k 0000:04:00.0: setting latency timer to 64 [ 80.712120] ath: EEPROM regdomain: 0x60 [ 80.712128] ath: EEPROM indicates we should expect a direct regpair map [ 80.712137] ath: Country alpha2 being used: 00 [ 80.712141] ath: Regpair used: 0x60 [ 80.768021] phy0: Selected rate control algorithm 'ath9k_rate_control' [ 80.770603] Registered led device: ath9k-phy0::radio [ 80.770816] Registered led device: ath9k-phy0::assoc [ 80.771612] Registered led device: ath9k-phy0::tx [ 80.771871] Registered led device: ath9k-phy0::rx [ 80.771933] phy0: Atheros AR9280 MAC/BB Rev:2 AR5133 RF Rev:d0: mem=0xffffc90003200000, irq=19 [ 80.831098] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 88.219743] wlan0: deauthenticating from 00:22:6b:62:72:0a by local choice (reason=3) [ 88.228706] wlan0: direct probe to AP 00:22:6b:62:72:0a (try 1) [ 88.423788] wlan0: direct probe to AP 00:22:6b:62:72:0a (try 2) [ 88.623779] wlan0: direct probe to AP 00:22:6b:62:72:0a (try 3) [ 88.823782] wlan0: direct probe to AP 00:22:6b:62:72:0a timed out [ 89.788421] ath9k: Failed to stop TX DMA in 100 msec after killing last frame [ 89.788443] ath9k: Unable to stop TxDMA. Reset HAL! [ 99.408412] wlan0: direct probe to AP 00:22:6b:62:72:0a (try 1) [ 99.415011] wlan0: direct probe responded [ 99.415022] wlan0: authenticate with AP 00:22:6b:62:72:0a (try 1) [ 99.417212] wlan0: authenticated [ 99.417252] wlan0: associate with AP 00:22:6b:62:72:0a (try 1) [ 99.421767] wlan0: RX AssocResp from 00:22:6b:62:72:0a (capab=0x411 status=0 aid=1) [ 99.421775] wlan0: associated [ 99.433445] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready -- ath9k disassociates/reassociates a lot https://bugs.launchpad.net/bugs/414560 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
