Finally disabling NCQ didnt work :(((( I was able to rebuild the array
(which I couldnt do before) but after 24h it still fail.
md1 : active raid1 sdb1[1] sda1[2](F)
976759936 blocks [2/1] [_U]
[ 2124.332991] ata3.00: exception Emask 0x0 SAct 0x0 SErr 0x400000 action 0x6
[ 2124.332996] ata3.00: BMDMA stat 0x24
[ 2124.332999] ata3: SError: { Handshk }
[ 2124.333007] ata3.00: cmd 35/00:10:07:11:92/00:00:57:00:00/e0 tag 0 dma 8192
out
[ 2124.333008] res 51/84:02:15:11:92/84:00:57:00:00/e0 Emask 0x10 (ATA
bus error)
[ 2124.333011] ata3.00: status: { DRDY ERR }
[ 2124.333013] ata3.00: error: { ICRC ABRT }
[ 2124.333019] ata3: hard resetting link
[ 2124.333021] ata3: nv: skipping hardreset on occupied port
[ 2124.822750] ata3: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[ 2124.901703] ata3.00: configured for UDMA/133
[ 2124.901721] ata3: EH complete
[ 8014.040045] ata5.00: exception Emask 0x0 SAct 0x0 SErr 0x180000 action 0x6
frozen
[ 8014.040051] ata5: SError: { 10B8B Dispar }
[ 8014.040059] ata5.00: cmd ca/00:00:3f:4c:27/00:00:00:00:00/e0 tag 0 dma
131072 out
[ 8014.040060] res 40/00:00:00:4f:c2/00:00:00:00:00/00 Emask 0x4
(timeout)
[ 8014.040063] ata5.00: status: { DRDY }
[ 8014.040069] ata5: hard resetting link
[ 8014.040071] ata5: nv: skipping hardreset on occupied port
[ 8014.530031] ata5: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[ 8014.593908] ata5.00: configured for UDMA/133
[ 8014.593917] ata5.00: device reported invalid CHS sector 0
[ 8014.593929] ata5: EH complete
[ 8044.953781] ata5.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6 frozen
[ 8044.953791] ata5.00: cmd ca/00:00:3f:4c:27/00:00:00:00:00/e0 tag 0 dma
131072 out
[ 8044.953793] res 40/00:00:00:4f:c2/00:00:00:00:00/00 Emask 0x4
(timeout)
[ 8044.953796] ata5.00: status: { DRDY }
[ 8044.953802] ata5: hard resetting link
[ 8044.953804] ata5: nv: skipping hardreset on occupied port
[ 8045.443789] ata5: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[ 8045.503927] ata5.00: configured for UDMA/133
[ 8045.503937] ata5.00: device reported invalid CHS sector 0
[ 8045.503949] ata5: EH complete
[ 8893.859651] md: data-check of RAID array md1
[ 8893.859655] md: minimum _guaranteed_ speed: 1000 KB/sec/disk.
[ 8893.859657] md: using maximum available idle IO bandwidth (but not more than
200000 KB/sec) for data-check.
[ 8893.859662] md: using 128k window, over a total of 976759936 blocks.
[ 9304.040036] ata3.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6 frozen
[ 9304.040047] ata3.00: cmd 25/00:00:bf:f9:f6/00:04:02:00:00/e0 tag 0 dma
524288 in
[ 9304.040048] res 40/00:00:00:4f:c2/84:00:57:00:00/00 Emask 0x4
(timeout)
[ 9304.040051] ata3.00: status: { DRDY }
[ 9304.040057] ata3: hard resetting link
[ 9304.040059] ata3: nv: skipping hardreset on occupied port
[ 9309.582556] ata3: link is slow to respond, please be patient (ready=0)
[ 9314.083762] ata3: SRST failed (errno=-16)
[ 9314.083770] ata3: hard resetting link
[ 9314.083773] ata3: nv: skipping hardreset on occupied port
[ 9319.610054] ata3: link is slow to respond, please be patient (ready=0)
[ 9324.131265] ata3: SRST failed (errno=-16)
[ 9324.131273] ata3: hard resetting link
[ 9324.131276] ata3: nv: skipping hardreset on occupied port
[ 9329.662533] ata3: link is slow to respond, please be patient (ready=0)
[ 9359.152521] ata3: SRST failed (errno=-16)
[ 9359.152528] ata3: limiting SATA link speed to 1.5 Gbps
[ 9359.152533] ata3: hard resetting link
[ 9359.152536] ata3: nv: skipping hardreset on occupied port
[ 9364.181269] ata3: SRST failed (errno=-16)
[ 9364.181274] ata3: reset failed, giving up
[ 9364.181277] ata3.00: disabled
[ 9364.181305] ata3.00: device reported invalid CHS sector 0
[ 9364.181318] ata3: EH complete
[ 9364.181338] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.181340] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.181344] end_request: I/O error, dev sda, sector 49740223
[ 9364.181382] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.181384] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.181387] end_request: I/O error, dev sda, sector 49741247
[ 9364.181410] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.181411] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.181414] end_request: I/O error, dev sda, sector 49742271
[ 9364.181434] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.181435] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.181438] end_request: I/O error, dev sda, sector 49743295
[ 9364.181455] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.181456] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.181459] end_request: I/O error, dev sda, sector 1953519935
[ 9364.181463] end_request: I/O error, dev sda, sector 1953519935
[ 9364.181467] md: super_written gets error=-5, uptodate=0
[ 9364.181470] raid1: Disk failure on sda1, disabling device.
[ 9364.181471] raid1: Operation continuing on 1 devices.
[ 9364.201309] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.201314] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.201318] end_request: I/O error, dev sda, sector 49743295
[ 9364.201356] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.201358] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.201360] end_request: I/O error, dev sda, sector 49742271
[ 9364.201473] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.201474] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.201477] end_request: I/O error, dev sda, sector 49743423
[ 9364.201557] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.201559] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.201561] end_request: I/O error, dev sda, sector 49741247
[ 9364.201654] sd 2:0:0:0: [sda] Unhandled error code
[ 9364.201656] sd 2:0:0:0: [sda] Result: hostbyte=DID_BAD_TARGET
driverbyte=DRIVER_OK
[ 9364.201658] end_request: I/O error, dev sda, sector 49740223
[ 9364.202140] md: md1: data-check done.
[ 9364.400027] RAID1 conf printout:
[ 9364.400032] --- wd:1 rd:2
[ 9364.400035] disk 0, wo:1, o:0, dev:sda1
[ 9364.400037] disk 1, wo:0, o:1, dev:sdb1
[ 9364.433841] RAID1 conf printout:
[ 9364.433845] --- wd:1 rd:2
[ 9364.433848] disk 1, wo:0, o:1, dev:sdb1
--
SATA error after updating Kernel 2.6.31-19
https://bugs.launchpad.net/bugs/518259
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
