Public bug reported: Binary package hint: linux-image-2.6.17-10-generic
Hi, here is the dmesg of the boot, regarding tg3 loading and the card getting up. As you can see it takes a while... this is with edgy, I believe I installed some of these box with dapper in the past and I did not notice such slowness, so maybe it's edgy only. the slowness can be noticed during boot when dhclient is started, instead of immediately showing immediately the dhclient output : "For info, please visit http://www.isc.org/sw/dhcp/ Listening on LPF/eth0/00:18:8b:1e:de:ac dhclient: Sending on LPF/eth0/00:18:8b:1e:de:ac ..." it sits for a while on "Listening on", it looks like it can't get acces to eth0 to get the mac address. this is edgy with all updates as of today of course : Linux xxxxxx 2.6.17-10-generic #2 SMP Tue Dec 5 22:28:26 UTC 2006 i686 GNU/Linux I have repeatedly seen this over at least 3 machines of this kind. I also tried changing the other side of the network link (the switch), it did not change this behavior at all. [17179587.284000] tg3.c:v3.59.1 (August 25, 2006) [17179587.284000] ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 169 [17179587.284000] PCI: Setting latency timer of device 0000:02:00.0 to 64 [17179587.376000] eth0: Tigon3 [partno(BCM5751PKFBG) rev 4001 PHY(5750)] (PCI Express) 10/100/1000BaseT Ethernet 00:18:8b:1e:de:ac [17179587.376000] eth0: RXcsums[1] LinkChgREG[1] MIirq[1] ASF[0] Split[0] WireSpeed[1] TSOcap[1] [17179587.376000] eth0: dma_rwctrl[76180000] dma_mask[64-bit] [17179587.448000] ACPI: PCI Interrupt 0000:00:1e.2[A] -> GSI 23 (level, low) -> IRQ 58 [17179587.448000] PCI: Setting latency timer of device 0000:00:1e.2 to 64 [17179587.504000] sd 0:0:0:0: Attached scsi generic sg0 type 0 [17179587.524000] ts: Compaq touchscreen protocol output [17179587.768000] intel8x0_measure_ac97_clock: measured 54291 usecs [17179587.768000] intel8x0: clocking to 48000 [17179587.944000] lp0: using parport0 (interrupt-driven). [17179588.004000] fuse init (API version 7.6) [17179588.036000] Adding 3004112k swap on /dev/disk/by-uuid/9ddb21b7-2fe0-4ff5-9731-589c0cc7b7b8. Priority:-1 extents:1 across:3004112k [17179588.104000] EXT3 FS on sda1, internal journal [17179713.036000] NET: Registered protocol family 17 [17179713.996000] tg3: eth0: Link is up at 100 Mbps, full duplex. [17179713.996000] tg3: eth0: Flow control is off for TX and off for RX. lspci : 02:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5751 Gigabit Ethernet PCI Express (rev 01) Subsystem: Dell Optiplex GX620 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0, Cache Line Size: 64 bytes Interrupt: pin A routed to IRQ 169 Region 0: Memory at fe8f0000 (64-bit, non-prefetchable) [size=64K] Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold+) Status: D0 PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data Capabilities: [58] Message Signalled Interrupts: 64bit+ Queue=0/3 Enable- Address: 80501a349e404b04 Data: 420e Capabilities: [d0] Express Endpoint IRQ 0 Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag+ Device: Latency L0s <4us, L1 unlimited Device: AtnBtn- AtnInd- PwrInd- Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported- Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop- Device: MaxPayload 128 bytes, MaxReadReq 4096 bytes Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 0 Link: Latency L0s <4us, L1 <64us Link: ASPM Disabled RCB 64 bytes CommClk+ ExtSynch- Link: Speed 2.5Gb/s, Width x1 Capabilities: [100] Advanced Error Reporting Capabilities: [13c] Virtual Channel ** Affects: linux-source-2.6.17 (Ubuntu) Importance: Undecided Status: Unconfirmed -- dell optiplex gx620, module tg3 initialisation slowness (slow boot) https://launchpad.net/bugs/83725 -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
