Hi people, Upon repeated insertion and removal of the card, eventually this is found in the /var/log/syslog : (machine is an IBM thinkpad g40)
Nov 27 22:22:01 - kernel: [ 1231.120049] pccard: CardBus card inserted into slot 0 Nov 27 22:22:01 - kernel: [ 1231.120102] PCI: 0000:03:00.0 reg 10 32bit mmio: [0, 1fff] Nov 27 22:22:01 - kernel: [ 1231.120163] pci 0000:03:00.0: supports D1 Nov 27 22:22:01 - kernel: [ 1231.120165] pci 0000:03:00.0: supports D2 Nov 27 22:22:01 - kernel: [ 1231.120168] pci 0000:03:00.0: PME# supported from D0 D1 D2 D3hot D3cold Nov 27 22:22:01 - kernel: [ 1231.120175] pci 0000:03:00.0: PME# disabled Nov 27 22:22:01 - kernel: [ 1231.131699] prism54pci 0000:03:00.0: enabling device (0000 -> 0002) Nov 27 22:22:01 - kernel: [ 1231.132154] prism54pci 0000:03:00.0: PCI INT A -> Link[LNKB] -> GSI 11 (level, low) -> IRQ 11 Nov 27 22:22:01 - kernel: [ 1231.132180] prism54pci 0000:03:00.0: setting latency timer to 64 Nov 27 22:22:01 - kernel: [ 1231.182381] firmware: requesting isl3886 Nov 27 22:22:01 - kernel: [ 1231.260232] p54: LM86 firmware Nov 27 22:22:01 - kernel: [ 1231.260246] p54: FW rev 2.7.0.0 - Softmac protocol 4.1 Nov 27 22:22:02 - kernel: [ 1232.595650] p54: unknown eeprom code : 0x1 Nov 27 22:22:02 - kernel: [ 1232.595661] p54: unknown eeprom code : 0x3 Nov 27 22:22:02 - kernel: [ 1232.595664] p54: unknown eeprom code : 0x1905 Nov 27 22:22:02 - kernel: [ 1232.595669] p54: unknown eeprom code : 0x1007 Nov 27 22:22:02 - kernel: [ 1232.595672] p54: unknown eeprom code : 0x1008 Nov 27 22:22:02 - kernel: [ 1232.595674] p54: unknown eeprom code : 0x1100 Nov 27 22:22:02 - kernel: [ 1232.605982] phy5: Selected rate control algorithm 'pid' Nov 27 22:22:02 - kernel: [ 1232.608901] phy5: hwaddr 00:0e:6a:d3:2a:8b, isl3890 Nov 27 22:22:02 - nm-system-settings: SCPlugin-Ifupdown: devices added (udi: /org/freedesktop/Hal/devices/net_00_0e_6a_d3_2a_8b_0, iface: wlan0) Nov 27 22:22:02 - NetworkManager: <info> wlan0: driver is 'prism54pci'. Nov 27 22:22:02 - NetworkManager: <info> wlan0: driver supports SSID scans (scan_capa 0x01). Nov 27 22:22:02 - NetworkManager: <info> Found new 802.11 WiFi device 'wlan0'. Nov 27 22:22:02 - NetworkManager: <info> (wlan0): exported as /org/freedesktop/Hal/devices/net_00_0e_6a_d3_2a_8b_0 Nov 27 22:22:06 - NetworkManager: <info> (wlan0): device state change: 1 -> 2 Nov 27 22:22:06 - NetworkManager: <info> (wlan0): bringing up device. Nov 27 22:22:06 - kernel: [ 1236.726717] firmware: requesting isl3886 Nov 27 22:22:06 - kernel: [ 1236.818261] ADDRCONF(NETDEV_UP): wlan0: link is not ready Nov 27 22:22:06 - NetworkManager: <info> (wlan0): preparing device. Nov 27 22:22:06 - NetworkManager: <info> (wlan0): deactivating device (reason: 2). Nov 27 22:22:06 - NetworkManager: <info> (wlan0): device state change: 2 -> 3 Nov 27 22:22:06 - NetworkManager: <info> (wlan0): supplicant interface state change: 1 -> 2. Nov 27 22:22:26 - kernel: [ 1256.904068] phy5: tx overflow. Nov 27 22:22:26 - kernel: [ 1256.964047] phy5: tx overflow. Nov 27 22:22:26 - kernel: [ 1256.964059] phy5: tx overflow. ... The last line is repeated tens of times, and the card finds only one of the many access points normally visible. -- Wifi 3CRWE154G72 driver prism54pci does not work with Ubuntu 8.10 beta https://bugs.launchpad.net/bugs/287408 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
