I'm also having problems with my ipw2100 on a T41, and getting the
firmware restart messages, but in dmesg, the firmware appears to load.
I wonder if there might be another problem (this is Intrepid 2.6.27)

[EMAIL PROTECTED]:~/Downloads$ sudo iwconfig eth4 key 11122233344455566677788899
Error for wireless request "Set Encode" (8B2A) :
    SET failed on device eth4 ; Operation not supported.
[EMAIL PROTECTED]:~/Downloads$ sudo iwconfig eth4
eth4      IEEE 802.11b  ESSID:"himikeb4"  Nickname:"ipw2100"
          Mode:Managed  Frequency:2.422 GHz  Access Point: 00:12:88:DC:D0:E9   
          Bit Rate=11 Mb/s   Tx-Power:16 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off

It seems that it is not setting the wireless key.  Wireless was working great 
in 2.6.24.
Also, lsmod seems to show 0 next to ipw2100, not sure if that is significant.
I've tried disabling/enabling using the hotkey (I saw this somewhere else), and 
rmmod / modprobe ipw2100, with no luck.

sudo lspci -vvnn:
02:02.0 Network controller [0280]: Intel Corporation PRO/Wireless LAN 2100 3B 
Mini PCI Adapter [8086:1043] (rev 04)
        Subsystem: Intel Corporation Device [8086:2551]
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- 
Stepping- SERR+ FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 64 (500ns min, 8500ns max), Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at c0214000 (32-bit, non-prefetchable) [size=4K]
        Capabilities: [dc] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA 
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=1 PME-
        Kernel driver in use: ipw2100
        Kernel modules: ipw2100

More interesting stuff from dmesg:
[ 3179.878932] eth4: could not initialize WEP: load module ieee80211_crypt_wep
[ 3365.928077] ipw2100: exit - failed to send CARD_DISABLE command
[ 3531.348096] ipw2100: Fatal interrupt. Scheduling firmware restart.

Thanks for looking into this, let me know if I should post more debug
stuff.

-- 
ipw2100 - "Fatal interrupt. Scheduling firmware restart."
https://bugs.launchpad.net/bugs/24776
You received this bug notification because you are a member of Ubuntu
Bugs, which is a direct subscriber.

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to