Hello hyperair, 11_rtl8187_workaround does not work for me. After resume, the network is disabled. I need right-click on network applet and "enable network".
'sudo ifconfig wlan0 down' does not result in any messages and the network applet still showing connected state. But 'ifconfig' does not show wlan0 anymore; it is really down. 'sudo rmmod rtl8187' results in "usbcore: deregistering interface driver rtl8187" as expected, and now the network applet shows disconnected state. 'sudo modprobe rtl8187' results in: [ 9878.087131] rtl8187: 8187B chip detected. Support is EXPERIMENTAL, and could damage your [ 9878.087136] hardware, use at your own risk [ 9878.092020] phy6: Selected rate control algorithm 'pid' [ 9878.092925] phy6: hwaddr 00:15:af:e9:c9:06, RTL8187BvE V0 + rtl8225z2 [ 9878.093797] usbcore: registered new interface driver rtl8187 And networkmanager reconnects as expected. I don't know why NetworkManager gets confused if I put the workaround after 10NetworkManager. What events 'org.freedesktop.NetworkManager.sleep' message causes? A note: I am using now '2.6.27-7-generic #1 SMP Tue Nov 4 19:33:06 UTC 2008 x86_64 GNU/Linux'. -- [intrepid] cannot suspend with module rtl8187 loaded https://bugs.launchpad.net/bugs/279798 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
