Help, I have an HP 5P scanner plugged into an qlogic scsi card. It has stopped working! I can't remember the last time it did work. I am using kubuntu 9:10 with the latest kernel updates etc. I know that the sg module is now built into the kernel but something is going wrong and I do not know how to fix things. The scsi card is recognised and appears when I "lspci"
-- 01:01.0 SCSI storage controller: Advanced Micro Devices [AMD] 53c974 [PCscsi] (rev 10) The driver for the scanner is correctly selected as tmscsim and this gets inserted automatically. dmesg has the following connected with it. [ 2.060366] DC390: clustering now enabled by default. If you get problems load [ 2.060370] with "disable_clustering=1" and report to maintainers [ 2.066283] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 19 [ 2.066290] alloc irq_desc for 19 on node 0 [ 2.066292] alloc kstat_irqs on node 0 [ 2.066303] tmscsim 0000:01:01.0: PCI INT A -> Link[LNKB] -> GSI 19 (level, low) -> IRQ 19 [ 2.697640] DC390_init: No EEPROM found! Trying default settings ... [ 2.697646] DC390: Used defaults: AdaptID=7, SpeedIdx=0 (10.0 MHz), DevMode=0x1f, AdaptMode=0x2f, TaggedCmnds=3 (16), DelayReset=1s [ 2.698698] scsi6 : Tekram DC390/AM53C974 V2.1d 2004-05-27 [ 2.699678] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 18 [ 2.699683] alloc irq_desc for 18 on node 0 [ 2.699686] alloc kstat_irqs on node 0 [ 5.665907] DC390: OLD Sync Nego code triggered! (6 0) Then that's as good as it gets. If I do a 'lsscsi -g' the scanner does not appear. It appears as though something is going wrong with the tmscsim module. I do not know where to go from here. Any help would be appreciated. ------------------------------------ Andrew Otte Laidley, Australia Ph: +61 7 54652172 Mobile: 0423804620 regc...@gmail.com o...@optusnet.com.au ----------------------------------- -- ubuntu-au mailing list ubuntu-au@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-au
