On Thu, Oct 25, 2012 at 03:46:01PM -0700, Joe Hershberger wrote: > Hi Stephen, > > On Thu, Oct 25, 2012 at 5:43 PM, Stephen Warren <swar...@wwwdotorg.org> wrote: > > On 10/25/2012 03:59 PM, Allen Martin wrote: > >> Add a new special environment variable "serial" that allows selection > >> of serial device when CONFIG_SERIAL_MULTI is defined. This replaces > >> the existing calls to serial_assign() from cmd_nvedit.c and iomux.c > >> that were not doing anything. > > > > So I think this requires (for example) the following environment variables: > > > > stdout=serial > > serial=eserial0 > > > > Is it possible to allow the following instead: > > > > stdout=eserial0 > > This is precisely what the patch I had pre-Marek serial did.
In your patch would "stdout=serial" still work for case where there is only one serial port? I think it's important to try to preserve that to no be too disruptive. > > > That way, one could presumably set: > > > > stdout=eserial0,eserial3 > > Though it didn't allow this. > Shouldn't that be (nearly) transparent through iomux? -Allen -- nvpublic _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
