Thanks for the response Merek. I got it working. I forgot to set the pad setting for the sdhc pins.
Thanks, Greg -----Original Message----- From: Marek Vasut [mailto:ma...@denx.de] Sent: Tuesday, October 02, 2012 6:18 AM To: u-boot@lists.denx.de Cc: Greg Topmiller Subject: Re: [U-Boot] Has anyone gotten the mmc commands to work on the NOVSOMTMi.MX6Q-SL-1-D, on the NOVPEK board by Novtech? Dear Greg Topmiller, > I am using release 2012.07 of u-boot with board type freescale/mx6qarm2. > The mx6qarm2 is what is used as the board type in the freescale u-boot > delivered with the board. We want to use the main line u-boot 2012.07. > To get it working I had to change the serial port and it boots ok. I > also noticed sdhc1 and sdhc2 were not being initialized with > fsl_esdhc_initialize. I tried to initialize them but it hangs on "mmc > rescan". I turned on CONFIG_MMC_TRACE and get the following. [..] Do you supply power to the card ? Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot