On 09/28/2012 10:56:51 AM, Lucas Stach wrote:
Add the missing bits to the Tegra NAND driver to make ONFI detection work
properly.

Also add it to the Tegra default config, as it seems to be a reasonable thing
to have it available on all boards that use any kind of NAND.

Signed-off-by: Lucas Stach <d...@lynxeye.de>
---
drivers/mtd/nand/tegra_nand.c | 36 ++++++++++++++++++++++++++++++++++++
 include/configs/tegra20-common.h |  1 +
 2 Dateien geändert, 37 Zeilen hinzugefügt(+)

diff --git a/drivers/mtd/nand/tegra_nand.c b/drivers/mtd/nand/tegra_nand.c
index 2c1b533..0d7ca5d 100644
--- a/drivers/mtd/nand/tegra_nand.c
+++ b/drivers/mtd/nand/tegra_nand.c
@@ -219,6 +219,34 @@ static uint8_t read_byte(struct mtd_info *mtd)
 }

 /**
+ * Read len bytes from the chip into a buffer
+ *
+ * @param mtd  MTD device structure
+ * @param buf  buffer to store data to
+ * @param len  number of bytes to read
+ *
+ * Read function for 8bit bus-width
+ */
+static void read_buf(struct mtd_info *mtd, uint8_t *buf, int len)
+{
+       int i, s;
+       unsigned int reg;
+       struct nand_chip *chip = mtd->priv;
+       struct nand_drv *info = (struct nand_drv *)chip->priv;
+
+       for (i = 0; i < len; i += 4) {
+               s = (len - i) > 4 ? 4 : len - i;
+               writel(CMD_PIO | CMD_RX | CMD_A_VALID | CMD_CE0 |
+                       ((s - 1) << CMD_TRANS_SIZE_SHIFT) | CMD_GO,
+                       &info->reg->command);
+               if (!nand_waitfor_cmd_completion(info->reg))
+                       printf("Command timeout during read_buf\n");
+               reg = readl(&info->reg->resp);
+               memcpy(buf + i, &reg, s);
+       }
+}

Out of curiousity, what is it about this that needed a custom read_buf() where you didn't need one before?

-Scott
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to