Hi Stefano, yes, the macro MEG_TO_AM () should work on my SOC (I see it is used on MPC8323RDB, my hw is quite similar to this one).
Thanks for your support Best regards, Agostino -----Messaggio originale----- Da: Stefano Babic [mailto:sba...@denx.de] Inviato: mercoledì 26 settembre 2012 16.41 A: SETTE AGOSTINO - technolabs Cc: u-boot@lists.denx.de Oggetto: Re: [U-Boot] Configure a Numonyx Axcell M29EW on a MPC8323 board On 25/09/2012 08:59, SETTE AGOSTINO - technolabs wrote: > Hi all, > > > (2 << BR_PS_SHIFT) | /* 16 bit port size */ \ > > BR_V) /* valid */ > > @ > > #define CONFIG_SYS_OR0_PRELIM 0x00007ff7 /* 512MB Flash size */ Without checking the manual, this seems wrong. It seems to me that the timing is set, but not the size. Does the macro MEG_TO_AM() work on your SOC ? Best regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
