On Sat, Sep 22, 2012 at 09:09:26AM -0500, Kumar Gala wrote: > Tom, > > Sorry for both sending this and the late request. I think Andy's been > swamped with some chip bringup and lost notice of window (thus my sending > this request). Would be good to get this stuff (and some fixes, etc) into > v2012.10. > > Thanks > > - k > > The following changes since commit ee1f4caaa2a3f79d692155eec8a4c7289d60e106: > Tom Rini (1): > Prepare v2012.10-rc1 > > are available in the git repository at: > > git://git.denx.de/u-boot-mpc85xx.git master > > Andy Fleming (1): > Revert "powerpc: Fix declaration type for I/O functions" > > Joakim Tjernlund (2): > mpc85xx: Initial SP alignment is wrong. > powerpc: Stack Pointer not properly aligned > > Kumar Gala (3): > Add e6500 processor detection > Add IFC offset for DPAA/Corenet platforms > Added new ext fields to IFC > > Liu Gang (6): > powerpc/corenet_ds: Update README.srio-boot-corenet > powerpc/corenet_ds: Get rid of the SRIOBOOT_MASTER build target > powerpc/corenet_ds: Get rid of the CONFIG_SRIOBOOT_SLAVE_PORTx macro > powerpc/corenet_ds: Update README and README.srio-pcie-boot-corenet > powerpc/corenet_ds: Master module for boot from PCIE > powerpc/corenet_ds: Slave module for boot from PCIE > > Matthew McClintock (6): > p1014rdb: set ddr bus width properly depending on SVR > p1010rdb: fix ddr values for p1014rdb (setting bus width to 16bit) > powerpc/p1010rdb: nandboot: compare SVR properly > nand_spl: update udelay for Freescale boards > nand_spl: p1023rds: wait before enabling DDR controller > nand_spl: change out_be32 to raw_writel and depend on subsequent sync > > Paul Gortmaker (1): > mpc85xx: use LCRR_DBYP define instead of raw constant > > Prabhakar Kushwaha (2): > powerpc/mpc85xx:Enable debugger support to missed e500v2 SoC > powerpc/mpc85xx: Add IFC LAW target ID for FSL High-End SoC > > Scott Wood (6): > nand/fsl_elbc: shrink SPL a bit by converting out_be32() to > __raw_writel() > powerpc/fsl-corenet: remove dead variant symbols > powerpc/fsl-corenet: work around erratum A004510 > powerpc/85xx: clear out TLB on boot > powerpc/p1_p2_rdb_pc: print -PC suffix in board name > powerpc/mpc85xx/p1_p2_rdb: add all LAWs during SPL > > Shaohui Xie (1): > powerpc/CoreNet: add tool to support pbl image build. > > Timur Tabi (6): > powerpc/85xx: add support for FM2 DTSEC5 > fm-eth: add function fm_info_get_phy_address() > powerpc/85xx: introduce function serdes_device_from_fm_port() > fm-eth: use fdt_status_disabled() function in ft_fixup_port() > powerpc/85xx: get rid of enum board_slots in P4080 MDIO driver > powerpc/85xx: remove support for the Freescale P3060 > > York Sun (14): > powerpc/mpc85xx: Make NMG_CPU_A011 workaround conditional > powerpc/mpc8xxx: Remove P1015 and P1016 from CPU list > powerpc/mpc8xxx: Add immap for topology and rcpm registers > powerpc/mpc8xxx: use topology registers to calculate number of cores > powerpc/mpc8xxx: fix core id for multicore booting > powerpc/mpc85xx: Skip zero values for DDR debug registers > powerpc/mpc8xxx: Add fine timing support for DDR3 > powerpc/mpc8xxx: Add support for cas latency 12 and above > powerpc/mpc8xxx: Enable 3-way and 4-way DDR interleaving > powerpc/mpc8xxx: Fix bug for extended DDR timing > powerpc/mpc8xxx DDR: Fix CAS latency calculation > powerpc/mpc8xxx DDR: Fall back to raw timing for first controller only > powerpc/mpc8xxx DDR: Fix interactive DDR debugging > powerpc/mpc8xxx: Move HWCONFIG_BUFFER_SIZE into config.h > > Makefile | 6 + > README | 37 +- > arch/powerpc/cpu/mpc85xx/Makefile | 10 - > arch/powerpc/cpu/mpc85xx/cmd_errata.c | 9 +- > arch/powerpc/cpu/mpc85xx/cpu.c | 15 +- > arch/powerpc/cpu/mpc85xx/cpu_init.c | 52 ++- > arch/powerpc/cpu/mpc85xx/ddr-gen3.c | 26 +- > arch/powerpc/cpu/mpc85xx/fdt.c | 7 +- > arch/powerpc/cpu/mpc85xx/fsl_corenet_serdes.c | 8 +- > arch/powerpc/cpu/mpc85xx/p3060_ids.c | 117 ----- > arch/powerpc/cpu/mpc85xx/p3060_serdes.c | 118 ----- > arch/powerpc/cpu/mpc85xx/release.S | 87 +++- > arch/powerpc/cpu/mpc85xx/speed.c | 3 +- > arch/powerpc/cpu/mpc85xx/start.S | 376 +++++++++++++-- > arch/powerpc/cpu/mpc8xxx/cpu.c | 68 ++- > arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c | 223 ++++----- > arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c | 25 +- > arch/powerpc/cpu/mpc8xxx/ddr/interactive.c | 26 +- > .../cpu/mpc8xxx/ddr/lc_common_dimm_params.c | 18 +- > arch/powerpc/cpu/mpc8xxx/ddr/main.c | 307 +++++++------ > arch/powerpc/cpu/mpc8xxx/ddr/options.c | 212 ++++++--- > arch/powerpc/cpu/mpc8xxx/ddr/util.c | 67 ++- > arch/powerpc/cpu/mpc8xxx/fdt.c | 3 +- > arch/powerpc/cpu/mpc8xxx/fsl_ifc.c | 12 + > arch/powerpc/cpu/mpc8xxx/srio.c | 153 +++---- > arch/powerpc/include/asm/config.h | 4 + > arch/powerpc/include/asm/config_mpc85xx.h | 133 +----- > arch/powerpc/include/asm/fsl_ddr_dimm_params.h | 1 + > arch/powerpc/include/asm/fsl_ddr_sdram.h | 8 + > arch/powerpc/include/asm/fsl_ifc.h | 18 +- > arch/powerpc/include/asm/fsl_law.h | 13 +- > arch/powerpc/include/asm/fsl_serdes.h | 1 + > arch/powerpc/include/asm/fsl_srio.h | 8 +- > arch/powerpc/include/asm/immap_85xx.h | 101 +++- > arch/powerpc/include/asm/io.h | 20 +- > arch/powerpc/include/asm/mmu.h | 4 + > arch/powerpc/include/asm/mp.h | 6 + > arch/powerpc/include/asm/processor.h | 8 +- > arch/powerpc/lib/board.c | 18 +- > board/freescale/common/Makefile | 2 - > board/freescale/common/fman.c | 31 ++ > board/freescale/common/fman.h | 2 + > board/freescale/common/p_corenet/law.c | 13 - > board/freescale/common/p_corenet/tlb.c | 18 +- > board/freescale/corenet_ds/eth_p4080.c | 59 +-- > board/freescale/corenet_ds/pbi.cfg | 51 +++ > board/freescale/corenet_ds/rcw_p3041ds.cfg | 11 + > board/freescale/corenet_ds/rcw_p4080ds.cfg | 11 + > board/freescale/corenet_ds/rcw_p5020ds.cfg | 11 + > board/freescale/mpc8540ads/mpc8540ads.c | 6 +- > board/freescale/mpc8541cds/mpc8541cds.c | 6 +- > board/freescale/mpc8555cds/mpc8555cds.c | 6 +- > board/freescale/mpc8560ads/mpc8560ads.c | 6 +- > board/freescale/p1010rdb/ddr.c | 7 +- > board/freescale/p1_p2_rdb_pc/law.c | 2 - > board/freescale/p3060qds/Makefile | 54 --- > board/freescale/p3060qds/README | 110 ----- > board/freescale/p3060qds/ddr.c | 248 ---------- > board/freescale/p3060qds/eth.c | 482 > -------------------- > board/freescale/p3060qds/fixed_ddr.c | 214 --------- > board/freescale/p3060qds/p3060qds.c | 342 -------------- > board/freescale/p3060qds/p3060qds_qixis.h | 74 --- > boards.cfg | 13 +- > common/env_remote.c | 4 +- > common/image.c | 1 + > doc/README.fsl-ddr | 36 +- > doc/README.pblimage | 114 +++++ > doc/README.srio-boot-corenet | 103 ----- > doc/README.srio-pcie-boot-corenet | 112 +++++ > drivers/misc/fsl_law.c | 54 +++ > drivers/net/fm/Makefile | 2 - > drivers/net/fm/init.c | 30 +- > drivers/net/fm/p3060.c | 97 ---- > drivers/pci/fsl_pci_init.c | 116 +++++ > drivers/qe/uec.c | 15 +- > include/configs/P2041RDB.h | 58 ++- > include/configs/P3060QDS.h | 48 -- > include/configs/P4080DS.h | 1 + > include/configs/P5020DS.h | 2 +- > include/configs/corenet_ds.h | 83 ++-- > include/configs/p1_p2_rdb_pc.h | 10 +- > include/ddr_spd.h | 7 +- > include/fm_eth.h | 2 + > include/image.h | 1 + > nand_spl/board/freescale/common.c | 40 ++ > nand_spl/board/freescale/p1010rdb/Makefile | 6 +- > nand_spl/board/freescale/p1010rdb/nand_boot.c | 77 ++-- > nand_spl/board/freescale/p1023rds/Makefile | 6 +- > nand_spl/board/freescale/p1023rds/nand_boot.c | 59 ++- > nand_spl/board/freescale/p1_p2_rdb_pc/Makefile | 6 +- > nand_spl/board/freescale/p1_p2_rdb_pc/nand_boot.c | 60 ++- > nand_spl/nand_boot_fsl_elbc.c | 47 +- > tools/Makefile | 2 + > tools/mkimage.c | 15 + > tools/mkimage.h | 3 + > tools/pblimage.c | 331 ++++++++++++++ > .../p3060qds/p3060qds.h => tools/pblimage.h | 26 +- > 97 files changed, 2682 insertions(+), 2999 deletions(-) > delete mode 100644 arch/powerpc/cpu/mpc85xx/p3060_ids.c > delete mode 100644 arch/powerpc/cpu/mpc85xx/p3060_serdes.c > create mode 100644 board/freescale/corenet_ds/pbi.cfg > create mode 100644 board/freescale/corenet_ds/rcw_p3041ds.cfg > create mode 100644 board/freescale/corenet_ds/rcw_p4080ds.cfg > create mode 100644 board/freescale/corenet_ds/rcw_p5020ds.cfg > delete mode 100644 board/freescale/p3060qds/Makefile > delete mode 100644 board/freescale/p3060qds/README > delete mode 100644 board/freescale/p3060qds/ddr.c > delete mode 100644 board/freescale/p3060qds/eth.c > delete mode 100644 board/freescale/p3060qds/fixed_ddr.c > delete mode 100644 board/freescale/p3060qds/p3060qds.c > delete mode 100644 board/freescale/p3060qds/p3060qds_qixis.h > create mode 100644 doc/README.pblimage > delete mode 100644 doc/README.srio-boot-corenet > create mode 100644 doc/README.srio-pcie-boot-corenet > delete mode 100644 drivers/net/fm/p3060.c > delete mode 100644 include/configs/P3060QDS.h > create mode 100644 nand_spl/board/freescale/common.c > create mode 100644 tools/pblimage.c > rename board/freescale/p3060qds/p3060qds.h => tools/pblimage.h (60%)
Applied to u-boot/master, thanks! -- Tom
signature.asc
Description: Digital signature
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
