After this series the same binary will run on a Saberlite board using any of the pin compatible processors mx6 quad, mx6 duallite, or mx6 solo. This is accomplished using a plugin and a table built by mkimage.
I made it easy to revert back to the current method by removing #define USE_PLUGIN from imximage.cfg file so that it is easy to support a single processor. In that case, you should also add #define FOR_MX6Q/FOR_MX6DL/FOR_MX6SOLO/FOR_MX6SOLOLITE to select which processor you are building for. Patches 1-5 of the series are unchanged from version 1. Troy Kisky (21): imximage: make header variable length imximage: check dcd_len as entries added imximage: enable word writes for version2 header imximage: cleanup parsing imximage: add expression evaluation imximage: add plugin commands imximage.cfg: run files through C preprocessor mx6: add plugin file for use with imximage.cfg mx6q_4x_mt41j128.cfg: use symbols instead of hardcoded constants mx6q_4x_mt41j128.cfg: allow plugin to work mx6q_4x_mt41j128.cfg: enable plugin mode mx6q_4x_mt41j128.cfg: add comments mx6q_4x_mt41j128.cfg: use ddr3 mode for reset mx6q_4x_mt41j128.cfg: skip initiailizing non-existent memory mx6q_4x_mt41j128.cfg: reorder for more efficient storage mx6q_4x_mt41j128.cfg: force ZQ calibration mx6: soc: add get_cpu_type arch-mx6: add mx6dl_pins.h mx6qsabrelite: add support for mx6 solo/duallite mx6q_4x_mt41j128.cfg: add mx6 solo/duallite support mx6qsabrelite: change CONFIG_SYS_PROMPT Makefile | 3 +- arch/arm/cpu/armv7/mx6/Makefile | 5 +- arch/arm/cpu/armv7/mx6/plugin.S | 164 +++++ arch/arm/cpu/armv7/mx6/soc.c | 26 + arch/arm/include/asm/arch-mx6/imx-mkimage.h | 177 +++++ arch/arm/include/asm/arch-mx6/imx-regs.h | 1 + arch/arm/include/asm/arch-mx6/mx6dl_pins.h | 118 +++ arch/arm/include/asm/arch-mx6/sys_proto.h | 6 + board/esg/ima3-mx53/imximage.cfg | 120 +-- board/freescale/imx/ddr/mx6q_4x_mt41j128.cfg | 433 ++++++----- board/freescale/mx25pdk/imximage.cfg | 77 +- board/freescale/mx51evk/imximage.cfg | 114 +-- board/freescale/mx53ard/imximage_dd3.cfg | 83 ++- board/freescale/mx53evk/imximage.cfg | 86 +-- board/freescale/mx53loco/imximage.cfg | 83 ++- board/freescale/mx53smd/imximage.cfg | 83 ++- board/freescale/mx6qarm2/imximage.cfg | 88 +-- board/freescale/mx6qsabrelite/mx6qsabrelite.c | 231 ++---- board/freescale/mx6qsabrelite/pads.h | 172 +++++ board/genesi/mx51_efikamx/imximage_mx.cfg | 132 ++-- board/genesi/mx51_efikamx/imximage_sb.cfg | 126 ++-- board/ttcontrol/vision2/imximage_hynix.cfg | 295 ++++---- include/configs/mx6qsabrelite.h | 2 +- tools/imximage.c | 967 ++++++++++++++++++------- tools/imximage.h | 45 +- 25 files changed, 2389 insertions(+), 1248 deletions(-) create mode 100644 arch/arm/cpu/armv7/mx6/plugin.S create mode 100644 arch/arm/include/asm/arch-mx6/imx-mkimage.h create mode 100644 arch/arm/include/asm/arch-mx6/mx6dl_pins.h create mode 100644 board/freescale/mx6qsabrelite/pads.h -- 1.7.9.5 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
