> -----Original Message----- > From: Prafulla Wadaskar > Sent: 03 August 2012 11:58 > To: 'Karl O. Pinc'; u-boot@lists.denx.de > Subject: RE: [PATCH] cosmetic: Better explain how to use the kirkwood > kwbimage.cfg file. > > > > > -----Original Message----- > > From: Karl O. Pinc [mailto:k...@meme.com] > > Sent: 03 August 2012 08:22 > > To: Prafulla Wadaskar; u-boot@lists.denx.de > > Cc: Karl O. Pinc > > Subject: [PATCH] cosmetic: Better explain how to use the kirkwood > > kwbimage.cfg file. > > > > Hi, > > > > This adds to the documenation to explain how to use the > > kwbimage.cfg file necessary to generate an image with > > prefixed board setup values necessary for the kirkwood > > boards. > > > > Signed-off-by: Karl O. Pinc <k...@meme.com> > > --- > > doc/README.kwbimage | 17 ++++++++++++++--- > > 1 files changed, 14 insertions(+), 3 deletions(-) > > > > diff --git a/doc/README.kwbimage b/doc/README.kwbimage > > index 7f15e6d..e91c387 100644 > > --- a/doc/README.kwbimage > > +++ b/doc/README.kwbimage > > @@ -25,13 +25,24 @@ for ex. > > -T kwbimage -a 0x00600000 -e 0x00600000 \ > > -d u-boot.bin u-boot.kwb > > > > + > > kwbimage support available with mkimage utility will generate > > kirkwood boot > > -image that can be flashed on the board NAND/SPI flash > > +image that can be flashed on the board NAND/SPI flash. The make > > target > > +which uses mkimage to produce such an image is "u-boot.kwb". For > > example: > > + > > + export BUILD_DIR=/tmp/build > > + make distclean > > + make yourboard_config > > + make $BUILD_DIR/u-boot.kwb > > + > > > > Board specific configuration file specifications: > > ------------------------------------------------ > > -1. This file must present in the $(BOARDDIR) and the name should be > > - kwbimage.cfg (since this is used in Makefile) > > +1. This file must present in the $(BOARDDIR). The default name is > > + kwbimage.cfg. The name can be set as part of the full path > > + to the file using CONFIG_SYS_KWD_CONFIG (probably in > > + include/configs/<yourboard>.h). The path should look > like: > > + $(SRCTREE)/$(CONFIG_BOARDDIR)/<yourkwbimagename>.cfg > > 2. This file can have empty lines and lines starting with "#" as > > first > > character to put comments > > 3. This file can have configuration command lines as mentioned > below, > > -- > > Acked by: Prafulla Wadaskar <prafu...@marvell.com> > > I will pull this patch latter.
Applied to u-boot-marvell.git master branch Regards... Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
