On 20/08/2012 22:25, Fabio Estevam wrote: > Hi Stefano, > > On Mon, Aug 20, 2012 at 4:42 PM, stefano babic <sba...@denx.de> wrote: > >> With the flea3 I have made some clean-up, making the lowLevel_init.S >> essential. Same changes were not reported back to the mx35pdk. I am >> going also to put in a common place the functions to setup the DDR >> controller ( board_setup_sdram_bank() in the flea3 directory). This >> should allow to factorize some other code, reducing the lowlevel_init.S. > > Maybe even better would be to convert the init from lowlevel_init.S > into C code, like was done on mx31. > > It is much easier to debug/maintain C code then assemby.
Yes, agree. Regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
