This allows for two things:
- VBus GPIO may be used on other ports than the OTG one
- VBus GPIO may be low active if specified by DT
Signed-off-by: Lucas Stach <d...@lynxeye.de>
CC: Stephen Warren <swar...@wwwdotorg.org>
CC: Tom Warren <twar...@nvidia.com>
---
arch/arm/cpu/armv7/tegra20/usb.c | 35 +++++++++++++++++++----------------
1 Datei geändert, 19 Zeilen hinzugefügt(+), 16 Zeilen entfernt(-)
diff --git a/arch/arm/cpu/armv7/tegra20/usb.c b/arch/arm/cpu/armv7/tegra20/usb.c
index 84260e6..77966e5 100644
--- a/arch/arm/cpu/armv7/tegra20/usb.c
+++ b/arch/arm/cpu/armv7/tegra20/usb.c
@@ -137,24 +137,27 @@ static const u8 utmip_elastic_limit = 16;
/* UTMIP High Speed Sync Start Delay */
static const u8 utmip_hs_sync_start_delay = 9;
-/* Put the port into host mode (this only works for OTG ports) */
+/* Put the port into host mode */
static void set_host_mode(struct fdt_usb *config)
{
- if (config->dr_mode == DR_MODE_OTG) {
- /* Check whether remote host from USB1 is driving VBus */
- if (readl(&config->reg->phy_vbus_sensors) & VBUS_VLD_STS)
- return;
-
- /*
- * If not driving, we set the GPIO to enable VBUS. We assume
- * that the pinmux is set up correctly for this.
- */
- if (fdt_gpio_isvalid(&config->vbus_gpio)) {
- fdtdec_setup_gpio(&config->vbus_gpio);
- gpio_direction_output(config->vbus_gpio.gpio, 1);
- debug("set_host_mode: GPIO %d high\n",
- config->vbus_gpio.gpio);
- }
+ /*
+ * If we are an OTG port, check if remote host is driving VBus and
+ * bail out in this case.
+ */
+ if (config->dr_mode == DR_MODE_OTG &&
+ (readl(&config->reg->phy_vbus_sensors) & VBUS_VLD_STS))
+ return;
+
+ /*
+ * If not driving, we set the GPIO to enable VBUS. We assume
+ * that the pinmux is set up correctly for this.
+ */
+ if (fdt_gpio_isvalid(&config->vbus_gpio)) {
+ fdtdec_setup_gpio(&config->vbus_gpio);
+ gpio_direction_output(config->vbus_gpio.gpio,
+ (config->vbus_gpio.flags & FDT_GPIO_ACTIVE_LOW)
? 0 : 1);
+ debug("set_host_mode: GPIO %d %s\n", config->vbus_gpio.gpio,
+ (config->vbus_gpio.flags & FDT_GPIO_ACTIVE_LOW) ? "low" :
"high");
}
}
--
1.7.11.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
