On 14/06/2012 15:44, Dirk Behme wrote: > From: Michael Langer <michael.lan...@de.bosch.com> > > The commit "i.mx: fsl_esdhc: add the i.mx6q support" (4692708d) introduces > support for the i.MX6Q MMC host controller USDHC. > > MXC_IPG_PERCLK sets the clock to 66MHz. This seems to be the default clock > of the ESDHC IP found in < i.MX6 silicon. However, the default clock for the > USDHC > IP found in i.MX6 is 200MHz (MXC_ESDHC_CLK). This difference will cause a 3 > times > higher clock on SD_CLK than expected (see fsl_esdh.c -> set_sysctl()). > > Signed-off-by: Michael Langer <michael.lan...@de.bosch.com> > CC: Stefano Babic <sba...@denx.de> > CC: Jason Liu <r64...@freescale.com> > ---
Applied to u-boot-imx, thanks. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
