Hello All I am trying to use SPL to boot an AM3703-based overo board from NAND. SPL runs and seems to load u-boot correctly but u-boot does not run correctly.
When I use the same SPL and u-boot from MMC, everything boots fine. I have modified SPL slightly to add some extra debugging. Any ideas what's wrong? Boot from MMC looks like: >>board_init_f() >>spl:board_init_r() boot device - 6 OMAP SD/MMC: 0 reading u-boot.img spl: payload image: U-Boot 2011.12-00475-g92216bd-di load addr: 0x80007fc0 size: 25822 reading u-boot.img Jumping to U-Boot image entry point: 0x80008000 pointers to parameters: 0x87080000 First few instructions 80008000:ea000014 80008004:e59ff014 80008008:e59ff014 8000800c:e59ff014 80008010:e59ff014 80008014:e59ff014 80008018:e59ff014 8000801c:e59ff014 80008020:80008200 80008024:80008260 U-Boot 2011.12-00475-g92216bd-dirty (May 29 2012 - 11:17:15) etc... all the way to Linux. Boot from NAND looks like: >>board_init_f() >>spl:board_init_r() boot device - 2 spl_nand_load_image() Load header: 80000,800,80008000 spl: payload image: U-Boot 2011.12-00475-e92216bd-di load addr: 0x80007fc0 size: 25822 Call nand_spl_load_image(80000,3f0f4,80007fc0) spl_nand_load_image() returning... Jumping to U-Boot image entry point: 0x80008000 pointers to parameters: 0x87080000 First few instructions 80008000:ea000014 80008004:e59ff014 80008008:e59ff014 8000800c:e59ff014 80008010:e59ff014 80008014:e59ff014 80008018:e59ff014 8000801c:e59ff014 80008020:80008200 80008024:80008260 and then nothing. Thanks -- Charles _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
