On Fri, 18 May 2012 18:19:34 -0500, Scott Wood
<scottw...@freescale.com> wrote:
On Mon, May 07, 2012 at 09:29:30PM -0000, Stefan Roese wrote:
Without this patch, boot shows this messages upon NAND detection:
NAND: ONFI flash detected
ONFI param page 0 valid
ONFI flash detected
ONFI param page 0 valid
128 MiB
With this patch, its back to the U-Boot "standard":
NAND: 128 MiB
Tested on x600 (SPEAr600).
Signed-off-by: Stefan Roese <s...@denx.de>
Cc: Amit Virdi <amit.vi...@st.com>
Cc: Vipin Kumar <vipin.ku...@st.com>
Cc: Scott Wood <scottw...@freescale.com>
Acked-by: Amit Virdi <amit.vi...@st.com>
---
drivers/mtd/nand/nand_base.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
Applied to u-boot-nand-flash.
Thanks.
BTW, I don't see any boards enabling the ONFI code at the moment...
The pending (already posted) SPEAr patches will use it.
Thanks,
Stefan
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
