On Wed, 9 May 2012 12:13:04 +0200
Stefano Babic <sba...@denx.de> wrote:
> After an update to the MX51 reference manual (Rev. 5), the
> values of the PAD_CTL_DRV_VOT_LOW and PAD_CTL_DRV_VOT_HIGH
> are now clearly wrong:
>
> "Bit 13:
> High / Low Output Voltage Range. This bit selects the output voltage mode for
> SD2_CMD. 0 High output voltage mode
> 1 Low output voltage mode"
>
> The values are currently negated in code - fixed.
>
> Reported-by: David Jander <david.jan...@protonic.nl>
> Signed-off-by: Stefano Babic <sba...@denx.de>
> CC: Marek Vasut <marek.va...@gmail.com>
> CC: David Jander <david.jan...@protonic.nl>
> ---
> arch/arm/include/asm/arch-mx5/iomux.h | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm/include/asm/arch-mx5/iomux.h
> b/arch/arm/include/asm/arch-mx5/iomux.h
> index 760371b..e3765a3 100644
> --- a/arch/arm/include/asm/arch-mx5/iomux.h
> +++ b/arch/arm/include/asm/arch-mx5/iomux.h
> @@ -66,8 +66,8 @@ typedef enum iomux_pad_config {
> PAD_CTL_HYS_ENABLE = 0x1 << 8, /* Hysteresis enabled */
> PAD_CTL_DDR_INPUT_CMOS = 0x0 << 9,/* DDR input CMOS */
> PAD_CTL_DDR_INPUT_DDR = 0x1 << 9,/* DDR input DDR */
> - PAD_CTL_DRV_VOT_LOW = 0x0 << 13, /* Low voltage mode */
> - PAD_CTL_DRV_VOT_HIGH = 0x1 << 13,/* High voltage mode */
> + PAD_CTL_DRV_VOT_LOW = 0x1 << 13, /* Low voltage mode */
> + PAD_CTL_DRV_VOT_HIGH = 0x0 << 13,/* High voltage mode */
> } iomux_pad_config_t;
>
> /* various IOMUX input functions */
Acked!
thanks.
Best regards,
--
David Jander
Protonic Holland.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
