On Wed, May 2, 2012 at 5:56 PM, stefano babic <sba...@denx.de> wrote:
> No, I tested on a board with the Dialog PMIC, and it worked flawlessy. > Maybe someone else tesetd with a newer board.. I have both boards here. On a mx53loco with Dialog PMIC: MX53LOCO U-Boot > usb start (Re)start USB... USB: Register 10011 NbrPorts 1 USB EHCI 1.00 scanning bus for devices... 2 USB Device(s) found scanning bus for storage devices... 1 Storage Device(s) found scanning bus for ethernet devices... 0 Ethernet Device(s) found On a mx53loco with FSL PMIC: MX53LOCO U-Boot > usb start (Re)start USB... USB: Register 10011 NbrPorts 1 USB EHCI 1.00 scanning bus for devices... cannot reset port 1!? 1 USB Device(s) found scanning bus for storage devices... 0 Storage Device(s) found scanning bus for ethernet devices... 0 Ethernet Device(s) found I still have not figured out why it cannot reset the USB port in this case. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot