Dear Fabio Estevam,
> MXS SSP controller may have up to three chip selects per port: SS0, SS1 and
> SS2.
>
> Currently only SS0 is supported in the mxs_spi driver.
>
> Allow all the three chip select to work by selecting the desired one
> in bits 20 and 21 of the HW_SSP_CTRL0 register.
>
> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
Acked-by: Marek Vasut <ma...@denx.de>
> ---
> Changes since v1:
> - Check vor valid cs inside spi_cs_is_valid() (patch 1/2)
>
> drivers/spi/mxs_spi.c | 10 ++++++++++
> 1 files changed, 10 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/spi/mxs_spi.c b/drivers/spi/mxs_spi.c
> index e7237e7..7859536 100644
> --- a/drivers/spi/mxs_spi.c
> +++ b/drivers/spi/mxs_spi.c
> @@ -34,6 +34,8 @@
>
> #define MXS_SPI_MAX_TIMEOUT 1000000
> #define MXS_SPI_PORT_OFFSET 0x2000
> +#define MXS_SSP_CHIPSELECT_MASK 0x00300000
> +#define MXS_SSP_CHIPSELECT_SHIFT 20
>
> struct mxs_spi_slave {
> struct spi_slave slave;
> @@ -65,6 +67,8 @@ struct spi_slave *spi_setup_slave(unsigned int bus,
> unsigned int cs, {
> struct mxs_spi_slave *mxs_slave;
> uint32_t addr;
> + struct mx28_ssp_regs *ssp_regs;
> + int reg;
>
> if (!spi_cs_is_valid(bus, cs)) {
> printf("mxs_spi: invalid bus %d / chip select %d\n", bus, cs);
> @@ -82,7 +86,13 @@ struct spi_slave *spi_setup_slave(unsigned int bus,
> unsigned int cs, mxs_slave->max_khz = max_hz / 1000;
> mxs_slave->mode = mode;
> mxs_slave->regs = (struct mx28_ssp_regs *)addr;
> + ssp_regs = mxs_slave->regs;
>
> + reg = readl(&ssp_regs->hw_ssp_ctrl0);
> + reg &= ~(MXS_SSP_CHIPSELECT_MASK);
> + reg |= cs << MXS_SSP_CHIPSELECT_SHIFT;
> +
> + writel(reg, &ssp_regs->hw_ssp_ctrl0);
> return &mxs_slave->slave;
> }
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
