Hi Wolfgang,
The following changes since commit 3f0675d1a532dbf1fd906103e4b61a6fb842c257:
Merge branch '[email protected]' of
git://git.denx.de/u-boot-staging (2012-04-09 21:34:27 +0200)
are available in the git repository at:
git://git.denx.de/u-boot-arm master
Anatolij Gustschin (1):
ARM1136: add cache flush and invalidate operations
Bernhard Walle (2):
tricorder: Add UBIFS
tricorder: Load kernel from ubifs
Eric Nelson (3):
i.MX6: define CACHELINE_SIZE
i.MX6: implement enable_caches()
i.MX6: mx6qsabrelite: add cache commands if cache is enabled
Fabio Estevam (4):
mx28: Split the README into a common part and a m28 specific part
mx28evk: Add a README file
mx6qsabrelite: Add boot switch setting information into the README
mx6qsabrelite: Fix the serial console port
Igor Grinberg (1):
cm-t35: fix Ethernet reset timing
Joel Fernandes (1):
BeagleBoard: Remove userbutton command and use gpio command instead
Marek Vasut (4):
i.MX28: Fix initial stack pointer position
i.MX28: Allow coexistence of PIO and DMA mode for SD/MMC
DMA: Split the APBH DMA init into block and channel init
M28: Pull out CONFIG_APBH_DMA so it's always enabled
Stefano Babic (7):
ARM: 926ejs: use debug() for misaligned addresses
mx35: flea3: fix when cache functions are linked
mx35: mx35pdk: fix when cache functions are linked
MX31: mx31pdk: drop enable_caches from board file
ARM: add u-boot.imx as target for i.MX SOCs
ARM1136: MX35: Make asm routines volatile in cache ops
MX35: mx35pdk: wrong board revision
Tom Rini (2):
OMAP: Move omap1510inn to Unmaintained / Orphaned
hawkboard: Add CONFIG_SPL_LIBGENERIC_SUPPORT
Troy Kisky (1):
MX53: DDR: Fix ZQHWCTRL field TZQ_CS
Vikram Narayanan (4):
imx: Remove unneeded/repititive definitions from imx headers
imx: Add GPIO_TO_PORT macro in the mxc_gpio driver
imx: Use GPIO_TO_PORT macro in the gpio driver instead of (gpio >> 5)
imx: Return gpio_set_value in gpio_direction_output
MAINTAINERS | 7 +-
arch/arm/cpu/arm1136/cpu.c | 103 ++++++++++++-
arch/arm/cpu/arm926ejs/cache.c | 2 +-
arch/arm/cpu/arm926ejs/mx28/mx28.c | 6 +
arch/arm/cpu/armv7/config.mk | 3 +
arch/arm/cpu/armv7/mx6/soc.c | 8 +
arch/arm/include/asm/arch-mx28/dma.h | 4 +-
arch/arm/include/asm/arch-mx35/mx35_pins.h | 2 -
arch/arm/include/asm/arch-mx5/mx5x_pins.h | 2 -
arch/arm/include/asm/arch-mx6/imx-regs.h | 4 +-
board/cm_t35/cm_t35.c | 11 +-
board/freescale/mx31pdk/mx31pdk.c | 8 -
board/freescale/mx35pdk/mx35pdk.c | 11 --
board/freescale/mx53ard/imximage_dd3.cfg | 2 +-
board/freescale/mx53evk/imximage.cfg | 2 +-
board/freescale/mx53loco/imximage.cfg | 2 +-
board/freescale/mx53smd/imximage.cfg | 2 +-
board/ti/beagle/beagle.c | 55 -------
doc/README.m28 | 219
+--------------------------
doc/README.mx28_common | 226
++++++++++++++++++++++++++++
doc/README.mx28evk | 29 ++++
doc/README.mx6qsabrelite | 3 +-
drivers/dma/apbh_dma.c | 38 ++---
drivers/gpio/mxc_gpio.c | 12 +-
drivers/mmc/mxsmmc.c | 53 +++++++-
drivers/mtd/nand/mxs_nand.c | 11 +-
include/configs/flea3.h | 2 +
include/configs/hawkboard.h | 1 +
include/configs/m28evk.h | 8 +-
include/configs/mx28evk.h | 2 +-
include/configs/mx35pdk.h | 3 +-
include/configs/mx6qarm2.h | 2 +
include/configs/mx6qsabrelite.h | 8 +-
include/configs/omap3_beagle.h | 11 +-
include/configs/tricorder.h | 15 ++-
35 files changed, 522 insertions(+), 355 deletions(-)
create mode 100644 doc/README.mx28_common
create mode 100644 doc/README.mx28evk
Amicalement,
--
Albert.
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
