Add boot switch setting information into the README Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> --- doc/README.mx6qsabrelite | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/doc/README.mx6qsabrelite b/doc/README.mx6qsabrelite index 0498cba..6f2f534 100644 --- a/doc/README.mx6qsabrelite +++ b/doc/README.mx6qsabrelite @@ -31,7 +31,8 @@ Note: Replace sXx with the device representing the SD card in your system. Note: This writes SD card loader at address 0 2. Put this SD card into the slot for the large SD card (SD3 on the bottom of -the board) +the board). Make sure SW1 switch is at position "00", so that it can boot +from the fuses. 3. Power-up the SabreLite, press 'space' to enter command mode in the U-Boot (the default one the board is shipped with, starting from the SPI NOR) and -- 1.7.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
