Hi Albert,
please pull from u-boot-imx (rebased on current u-boot-arm).
The following changes since commit cd207cde948ecf9ff50a0fa1ae2650f65579c9c9:
IXP: Fix GPIO_INT_ACT_LOW_SET() (2012-03-26 23:09:26 +0200)
are available in the git repository at:
git://www.denx.de/git/u-boot-imx.git master
Dirk Behme (1):
imximage: Remove overwriting of flash_offset
Eric Nelson (4):
i.MX6: mx6qsabrelite: add ext2 support
mx6q: mx6qsabrelite: setup_spi() should be called in board_init to
allow use for environment
i.MX6: mx6q_sabrelite: add CONFIG_REVISION_TAG
i.MX6: mx6qsabrelite: add MACH_TYPE_MX6Q_SABRELITE
Fabio Estevam (15):
mx51evk: Fix CONFIG_SYS_MEMTEST_END
mx53evk: Fix CONFIG_SYS_MEMTEST_END
mx53smd: Fix CONFIG_SYS_MEMTEST_END
efikamx: Fix CONFIG_SYS_MEMTEST_END
mx31pdk: Fix CONFIG_SYS_MEMTEST_END
mx6: Fix reset cause for Power On Reset case
mx6: Remove duplicate definition of ANATOP_BASE_ADDR
pmic_i2c: Return error in case of invalid pmic_i2c_tx_num
mxs_spi: Return proper timeout error
mx6: Read silicon revision from register
USB: ehci-mx6: Add proper IO accessors
mx28evk: Provide default values for SPI bus and chip select
configs: imx: Use CONFIG_SF_DEFAULT_CS
mx53: Make PLL2 to be the parent of UART clock
mx53ard: Initialize return code with error
Helmut Raiger (1):
mx31: add "ARM11P power gating" to get_reset_cause
Marek Vasut (3):
i.MX28: Enable additional DRAM address bits
i.MX28: Make the stabilization delays shorter
i.MX28: Drop __naked function from spl_mem_init
arch/arm/cpu/arm1136/mx31/generic.c | 2 +
arch/arm/cpu/arm926ejs/mx28/spl_mem_init.c | 12 +--
arch/arm/cpu/arm926ejs/mx28/spl_power_init.c | 8 +-
arch/arm/cpu/armv7/imx-common/cpu.c | 25 ++++-
arch/arm/cpu/armv7/mx5/lowlevel_init.S | 20 +++-
arch/arm/cpu/armv7/mx6/soc.c | 8 ++-
arch/arm/include/asm/arch-mx6/imx-regs.h | 143
++++++++++++++++++++++++-
board/freescale/mx53ard/mx53ard.c | 2 +-
board/freescale/mx6qsabrelite/mx6qsabrelite.c | 13 ++-
drivers/misc/pmic_i2c.c | 6 +
drivers/spi/mxs_spi.c | 6 +-
drivers/usb/host/ehci-mx6.c | 13 +--
include/configs/efikamx.h | 4 +-
include/configs/m28evk.h | 2 +-
include/configs/mx28evk.h | 2 +
include/configs/mx31pdk.h | 2 +-
include/configs/mx51evk.h | 2 +-
include/configs/mx53evk.h | 2 +-
include/configs/mx53smd.h | 2 +-
include/configs/mx6qsabrelite.h | 4 +
include/configs/vision2.h | 2 +-
tools/imximage.c | 18 +++-
tools/imximage.h | 1 +
23 files changed, 251 insertions(+), 48 deletions(-)
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
