On 26/03/2012 01:00, Eric Nelson wrote:
> V2 has been stripped of the board-independent changes and
> uses clrsetbits_le32() instead of twiddling bits by hand.
>
> Signed-off-by: Eric Nelson <eric.nel...@boundarydevices.com>
> ---
Hi Eric,
> board/freescale/mx6qsabrelite/mx6qsabrelite.c | 32
> +++++++++++++++++++++++++
> include/configs/mx6qsabrelite.h | 13 ++++++++++
> 2 files changed, 45 insertions(+), 0 deletions(-)
>
> diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> index 1d09a72..afb1245 100644
> --- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> +++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> @@ -25,6 +25,8 @@
> #include <asm/arch/imx-regs.h>
> #include <asm/arch/mx6x_pins.h>
> #include <asm/arch/iomux-v3.h>
> +#include <asm/arch/ccm_regs.h>
> +#include <asm/arch/clock.h>
> #include <asm/errno.h>
> #include <asm/gpio.h>
> #include <mmc.h>
> @@ -267,6 +269,32 @@ int board_eth_init(bd_t *bis)
> return 0;
> }
>
> +#ifdef CONFIG_CMD_SATA
> +
> +int setup_sata(void)
> +{
> + int rval = enable_sata_clock();
What about to return at this point if there is an error ?
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
