On 23/03/2012 04:25, Troy Kisky wrote: > On 3/22/2012 6:47 PM, Troy Kisky wrote: >> On 3/22/2012 3:00 PM, Troy Kisky wrote: >>> Currently, board files are setting this field to 0x01 >>> which the manual says is a reserved value. Change to >>> use the default of 0x04 - 128 cycles. >> Typo, should say default of 0x02 - 128 cycles >> > Possibly the manual is wrong, and the value of 0x01 corresponds > to 64 cycles? My testing was on a DDR2 device where this field > is not relevant.
Is there someone who can answer to this question ? This patch fixes the value according to the manual, without doubts. But if the manual is wrong... Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
