The following warnings are reported for boards using SOFT ECC. omap_gpmc.c:33:30: warning: 'hw_nand_oob' defined but not used omap_gpmc.c:78:13: warning: 'omap_hwecc_init' defined but not used omap_gpmc.c:116:12: warning: 'omap_correct_data' defined but not used omap_gpmc.c:182:12: warning: 'omap_calculate_ecc' defined but not used omap_gpmc.c:208:13: warning: 'omap_enable_hwecc' defined but not used
Signed-off-by: Stefano Babic <sba...@denx.de> Cc: Tom Rini <tr...@ti.com> Cc: Scott Wood <scottw...@freescale.com> --- drivers/mtd/nand/omap_gpmc.c | 6 ++++++ 1 files changed, 6 insertions(+), 0 deletions(-) diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c index 1dfe074..3a9baff 100644 --- a/drivers/mtd/nand/omap_gpmc.c +++ b/drivers/mtd/nand/omap_gpmc.c @@ -30,7 +30,10 @@ #include <nand.h> static uint8_t cs; +#if !defined(CONFIG_SPL_BUILD) || \ + (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_NAND_SOFTECC)) static struct nand_ecclayout hw_nand_oob = GPMC_NAND_HW_ECC_LAYOUT; +#endif /* * omap_nand_hwcontrol - Set the address pointers corretly for the @@ -69,6 +72,8 @@ int omap_spl_dev_ready(struct mtd_info *mtd) } #endif +#if !defined(CONFIG_SPL_BUILD) || \ + (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_NAND_SOFTECC)) /* * omap_hwecc_init - Initialize the Hardware ECC for NAND flash in * GPMC controller @@ -231,6 +236,7 @@ static void omap_enable_hwecc(struct mtd_info *mtd, int32_t mode) break; } } +#endif #ifndef CONFIG_SPL_BUILD /* -- 1.7.5.4 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot