Am 28/02/2012 04:51, schrieb Marek Vasut: >> On 2/27/2012 3:56 PM, Marek Vasut wrote: >>>> |ARM: Update mach-types >>>> | >>>> |This commit updates the mach-types based on the latest in Linus's >>>> head | >>>> |Signed-off-by: Marek Vasut<marek.va...@gmail.com> >>>> >>>> Hi Marek, >>>> >>>> >>>> Can I get you to do this again? I'd the symbol for >>>> MACH_MX6Q_SABRELITE. >>> >>> No, can you please submit the mach-types update yourself? Thank you! >>> >> I don't think I'm trusted to do that. I think that some machines may >> have been removed >> from Linux that u-boot may want to keep. > > So these machines have to define their mach id in their config (and you need > to fix them after replacing mach-types). > > Since I only want to use the >> value in 1 place, >> is it acceptable to just use the hex value instead? > > No, either update the mach types (preffered) or ... Update the mach types ;)
It was discussed and accepted that the boards can set CONFIG_MACH_TYPE directly into the configuration file. In this way, we continue to support in U-Boot boards independently if they are pushed to Linux mainline or not. On the other side, everybody can send the current mach-types from the Linux kernel to Albert (ARM Maintainer) - if a board is already in kernel mainline is the preferred way. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
