Hi Marek,
> git rebase -i HEAD~3
> (if you have the patch you want to rework 3 patches deep)
> Change "pick" to the left of the patch to "edit"
> Do the change in the file.
> git add <file>
> git rebase --continue
> <submit>
May be tonight, at my hotel room.
> Lowering the clock to what ?
Down to 137MHz works for me. That's way too low, but at least it keeps my board
going.
But there's nothing wrong with a frequency of 206MHz, as configured currently;
We
just should up the CAS to RAS delay to 5 cycles, from the 3 configured
currently.
Perhaps others parameters need a little attention too, but there are so many
registers
for DDR to check here...
> I was pondering about this too, the settings in
> spl_mem_init are for DENX m28 board, so maybe someone should abstract that
> out.
I'm not happy with it either, but the way it is now seems to be the most common
one.
And due to the huge amount of registers, I doubt if it could be abstracted
nicely,
without turning it into an even bigger mess. I'm afraid there's little
alternatives to tuning
DDR parameters for each board separately.
Cheers,
Robert.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
