On 06/02/2012 15:55, Igor Grinberg wrote:
> Hi Stefano,
>
Hi Igor,
>> +#ifdef CONFIG_USB_EHCI
>> +
>> +static struct omap_usbhs_board_data usbhs_bdata = {
>> + .port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
>> + .port_mode[1] = OMAP_EHCI_PORT_MODE_PHY,
>> + .port_mode[2] = OMAP_EHCI_PORT_MODE_PHY,
>> +};
>
> OMAP EHCI port3 is TLL only, so the above does not look right...
This is a strange effect. I have tested setting OMAP_EHCI_PORT_MODE_PHY
(of course the phy is on another port), and everything works. However,
after setting port_mode[2] to OMAP_USBHS_PORT_MODE_NONE, it does not
work anymore and no storage are detected. I have not an explanation,
maybe some of you can give some hints. Really, the change should have no
effect...
>
> return omap_ehci_hcd_init(&usbhs_bdata);
Right, I'll fix
>
> return omap_ehci_hcd_stop();
I fix this, too
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
